Honeywell XP 1991i User manual

Granit™ XP 1991i
Cordless Industrial Area-Imaging Scanner
Quick Start Guide
1991-EN-QS-01 Rev (a)
12/19
-

1
Agency Model: 1991iSR and 1991iMR+
Note: Refer to your User Guide for information about cleaning
your device.
Getting Started
Turn off computer’s power before connecting the scanner, then
power up the computer once the scanner is fully connected.
When the base is connected and powered up, put the scanner in
the base to establish a link. The green LED on the base flashes
to indicate the scanner’s battery or charge pack is charging.
Power Supply Assembly (if included)
Note: The power supply must be ordered separately, if needed.
-

2
Connecting the Base
USB:
Note: If you are charging the scanner using the USB cable, the
current available for charging is reduced and charge times
are increased. Charging via the power supply is faster.

3
Keyboard Wedge:

4
RS232 Serial Port:

5
Reading Techniques
The view finder projects an aiming beam
that should be centered over the bar code,
but it can be positioned in any direction for
a good read.
Note: If the scanner beeps 3 times when
scanning a bar code, the link has not
been established. If the scanner
beeps once, the link has been
established.
Standard Product Defaults
The following bar code resets all standard product default set-
tings.
Standard Product Defaults

6
USB Serial
Scan the following code to program the scanner to emulate a
regular RS232-based COM Port. Apple® Macintosh computers
recognize the scanner as a USB CDC class device and automati-
cally use a class driver.
Note: No extra configuration (e.g., baud rate) is necessary.
USB PC Keyboard
Scan the following code to program the scanner for a USB PC
Keyboard.
If you are using a Microsoft® Windows® PC, you must
download a driver from the Honeywell website. The
driver will use the next available COM Port number.
USB Serial
USB PC Keyboard

7
Keyboard Country
Scan the appropriate country code below to program the key-
board layout for your country or language. By default, national
character replacements are used for the following characters:
#$@[\]^‘{|}~ Refer to the ISO 646 Character Replacements chart
in your User Guide to view the character replacements for each
country.
USA (Default)
Belgium
Denmark
Finland
France
Germany/Austria

8
Note: For a complete list of country codes, see the User Guide for
your product.
Locked Link
If you link a scanner to a base using the Locked Link Mode,
other scanners are blocked from being linked if they are inad-
vertently placed into the base. If you do place a different scan-
ner into the base, it will charge the scanner, but the scanner will
not be linked.
Great Britain
Italy
Norway
Spain
Switzerland
Locked Link Mode
(Single Scanner)

9
To use a different scanner, you need to unlink the original scan-
ner by scanning the Unlink Scanner bar code.
Override Locked Scanner
If you need to replace a broken or lost scanner that is linked to a
base, scan the Override Locked Scanner bar code with a new
scanner, and place that scanner in the base. The locked link will
be overridden; the broken or lost scanner’s link with the base will
be removed, and the new scanner will be linked.
Unlinking the Scanner
If the base has a scanner linked to it, that scanner must be
unlinked before a new scanner can be linked. Once the previous
scanner is unlinked, it will no longer communicate with the
base. Scan the Unlink Scanner bar code to unlink a scanner.
Override Locked Scanner
Unlink Scanner