horiba LAQUAact D-74 Installation guide

CODE:GZ0000340568B
January, 2017 © 2017 HORIBA Advanced Techno Co., Ltd.
Quick Manual
Portable pH/Conductivity Meter D-74
MEASCAL DATA
LIGHT
SETMODE
ENT
MEASCAL DATA
LIGHT
SETMODE
ENT
Preparation
② Press the power key of the meter
① Connect the electrode to the meter
③ Change the measurement parameter to conductivity
LIGHT
ENT
Press or
Press
http://www.horiba-water.com
Temperature connectorElectrode connector
Conductivity measurement

MEASCAL DATA
LIGHT
SETMODE
ENT
MEASCAL DATA
LIGHT
SETMODE
ENT
MEASCAL DATA
LIGHT
SETMODE
ENT
×3
MEASCAL DATA
LIGHT
SETMODE
ENT
②Start the measurement
①Enter the set up mode ①Enter the measurement mode②Set the cell constant
Press
Set the cell constant
MEASCAL DATA
SETMODE
Immerse up to
the hole in the
lower part of
the cell.
Press
When changes from the blinking state
to the lit state, measurement is complete.
Press three times
Press
Press
Measurement
When the batteries run out or the meter will not be used
for a long period, remove the batteries.
NOTE
MEASCAL DATA
LIGHT
SETMODE
ENT
MEASCAL DATA
LIGHT
SETMODE
ENT
3552-10D
1.065 × 100 m -1（1cm-1)
Check the label on the electrode.
Example)
②①
① Press to set the digit
number of cell constant.
Register it with .
② Press to set the number
of cell constant.
Change the digit with .
Register it with .
To measurement
③ Press to reect the changes.