horiba LAQUAact D-75 Installation guide

CODE:GZ0000340570A
January, 2017 © 2017 HORIBA Advanced Techno Co., Ltd.
MEASCAL DATA
LIGHT
SETMODE
ENT
MEASCAL DATA
LIGHT
SETMODE
ENT
LIGHT
ENT
Quick Manual
Portable pH/Dissolved Oxygen Meter D-75
Preparation
① Connect the electrode to the meter
② Press the power key of the meter
③ Change the measurement parameter to dissolved oxygen
Press
Press or
http://www.horiba-water.com
Temperature connectorElectrode connector
Dissolved oxygen measurement

MEASCAL DATA
LIGHT
SETMODE
ENT
MEASCAL DATA
SETMODE
MEASCAL DATA
LIGHT
SETMODE
ENT
MEASCAL DATA
SETMODE
ENT
MEASCAL DATA
LIGHT
SETMODE
ENT
If high precision measurement is necessary, perform calibration using the standard solution.
About calibration using the standard solution, refer to the instruction manual.
Calibration
①Enter the calibration mode
Press
Hold the electrode still in clear air.
② Start the air calibration
To measurement
When changes from the blinking
state to the lit state and calibrated value
appears, calibration is complete.
②Start the measurement
①Enter the measurement mode
MEASCAL DATA
SETMODE
Press
When changes from the blinking state
to the lit state, measurement is complete.
Immerse 6 cm
or more.
Measurement
Press
Conrm that the
instantaneous value
is stable, then
press .
When the batteries run out or the meter will not be used
for a long period, remove the batteries.
NOTE