7
The handle can later be detached and installed on the opposite side if you change
Then measure the distance from where the Swing Arm is
visible on the Crossover to the point where the Swing Arm ends. Make certain both
the Swing Arm with Self Taping Screws.
Figure 9
Make certain the Cover is square on the spa. Be sure to place a piece of rigid
material to protect the cover while you are
installing the screws. Damage to the cover
warranty.
install the 2nd Ball Stud on Hole #1 facing outward of the Swing Arm and secure it
then install the large barrel of a Gas Spring onto the Ball
Stud on the Swing Arm and the narrow barrel into the
Hole # 1 is most preferred because it requires
the least amount of pressure to raise the cover. Hole
#3 requires the least amount of pressure to close
the cover. Moving from one hole to the other can
easily be done later. Also, the Lower Hole you use
the further back the cover will sit.
Figure 11
Step 13 Step 4
Step 12
A
Step 4
Figure 10
