HP Media Center m200 - Desktop PC Installation manual

Remote Sensor
Connect remote control
receiver to computer
TV Out (TV connections are optional)
TV signal from computer to TV
Power On
If you use a cable or satellite
set-top box, pass the signal
through the remote sensor
Computer to
electrical outlet
Turn on monitor,
computer, and
subwoofer
If you use a cable or satellite set-top box,
pass the signal through the box
67
HP Support Web site:
http://www.hp.com/support
HP Customer Care Center
1-800-HP-INVENT
Hours: 24 hours, 7 days
HP Registration Web site:
http://register.hp.com
VIDEO IN
S-VID OUT
COMP OUT
TV
Cable or
satellite set-top box
8
9
TV In
Connect TV signal to computer
IN
FROM
ANT
OUT
TO
TV
Signal
Signal
Signal
Locate IR window
on set-top box.
Adhere to IR window.
Remove
backing tape
S-VID IN
TV
S-VID IN
TV
or
or
Cable or
antenna
Cable or satellite set-top box
Remote
sensor
control
cable
EPC setup poster Side 2 3/26/03 TRIM SIZE: 19 x 21” Bar code MUST be replaced by Wasser, Seattle!
Second coaxial
cable not included
Read your User’s Guide
Register your PC
Setup your Internet
Service Provider
Coaxial cable
Coaxial cable Composite video cable
©2002, 2003 Hewlett-Packard Development Company, L.P. All rights reserved.
See “Enabling TV
Out Image” in the
Hardware User’s Guide
for TV display setup