HP Armada 7800 Technical document

. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Appendix
B
Power Cord Set Requirements B-1
Power Cord Set
Requirements
3-Conductor Power Cord Set
The wide range input feature of the Broadway Family of Personal Computers permits it
to operate from any line voltage from 100 to 120 or 220 to 240 volts AC.
The power cord set received with the computer meets the requirements for use in the
country where the equipment is purchased.
Power cord sets for use in other countries must meet the requirements of the country
where the computer is used. For more information on power cord set requirements,
contact a Compaq authorized reseller or service provider.
General Requirements
The requirements listed below are applicable to all countries:
1. The length of the power cord set must be at least 5.00 feet (1.5 m) and a maximum
of 6.50 feet (2.0 m).
2. All power cord sets must be approved by an acceptable accredited agency
responsible for evaluation in the country where the power cord set will be used.
3. The power cord set must have a minimum current capacity of 10A and a nominal
voltage rating of 125 or 250 volts AC, as required by each country’s power system.
4. The appliance coupler must meet the mechanical configuration of an EN 60 320/IEC
320 Standard Sheet C13 connector, for mating with appliance inlet on the back of the
computer.

. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
B-2 Power Cord Set Requirements
Country-Specific Requirements
3-Conductor Power Cord Set Requirements—By Country
Country Accredited Agency Applicable Note Numbers
Australia EANSW 1
Austria OVE 1
Belgium CEBC 1
Canada CSA 2
Denmark DEMKO 1
Finland FIMKO 1
France UTE 1
Germany VDE 1
Italy IMQ 1
Japan JIS 3
The Netherlands KEMA 1
Norway NEMKO 1
Sweden SEMKO 1
Switzerland SEV 1
United Kingdom BSI 1
United States UL 2
Notes
1. The flexible cord must be <HAR> Type HO5VV-F, 3-conductor, 1.0 mm2
conductor size. Power cord set fittings (appliance coupler and wall plug) must bear
the certification mark of the agency responsible for evaluation in the country where
it will be used.
2. The flexible cord must be Type SPT-3 or equivalent, No. 18 AWG, 3-conductor.
The wall plug must be a two-pole grounding type with a NEMA 5-15P (15A, 125V)
or NEMA 6-15P (15A, 250V) configuration.
3. The appliance coupler, flexible cord, and wall plug must bear a "T" mark and
registration number in accordance with the Japanese Dentori Law. The flexible cord
must be Type VCT or VCTF, 3-conductor, 0.75mm2conductor size. The wall plug
must be a two-pole grounding type with a Japanese Industrial Standard C8303
(15A, 125V) configuration.