Huawei E182E HSPA+ Troubleshooting guide

HUAWEI E182E HSPA+ USB
Slider
Quick Start
Thank you for choosing this USB Slider. With the
USB Slider, you can access the Internet through
wireless network at a high speed.
Note:
This manual describes the appearance, installation and removal of the USB Slider.
For the operation of the management program, refer to the User Manual.
Getting to Know Your USB Slider
The following figure shows the appearance of the USB Slider. It is only for your
reference. The actual product may differ.
1
5
2
34
nUSB Interface
It connects the USB Slider to a computer.
oSlider
It reveals the USB connector
pIndicator
It indicates the status of the USB Slider.
Green, blinking (on for 100ms and off for 100ms; then on for 100ms and off for
2700ms), the USB Slider is powered on.
Green, blinking (on for 100ms and off for 2900ms), the USB Slider is registered
to a GSM/GPRS/EDGE network.
Blue, blinking (on for100ms and off for 2900ms), the USB Slider is registered
to a UMTS network.

Green, on, the USB Slider is connected to a GPRS/EDGE network.
ected to a HSPA+ network.
ff
Slot
w er identity module/UMTS subscriber identity
rMicro SD Card Slot
card
1. der.
card into the card slots. Make sure
3.
Blue, on, the USB Slider is connected to a WCDMA network.
Cyan, on, the USB Slider is conn
O , the USB Slider is removed.
qSIM/USIM Card
It is here you insert the subscrib
module (SIM/USIM) card.
It is where you insert the Micro Secure Digital Memory (SD)
Getting Your USB Slider Ready
Remove the back cover of the USB Sli
2. Insert the USIM/SIM card and the micro SD
that the cards are properly inserted.
Install the back cover of the USB Slider.
Note:
Do not remove the Micro SD card when it is being used. Removing the card during
ice, and data stored
val procedures
rst, power on the computer. Then connect the USB Slider with the computer.
interface of the laptop or desktop computer.
an operation maydamage the Micro SD card as well as the dev
on the card may be corrupted.
Installation/Removal Guide
On different operating systems (OSs), the installation and remo
may differ. Follow the system prompts during operation.
Connecting the USB Slider with a Computer
Note:
Fi
Otherwise, the USB Slider cannot be installed as normal.
1. Plug the USB Slider into the USB
ew hardware and starts the
3. izard.
r the USB Slider management
2. The OS automatically detects and recognises n
installation wizard.
Follow the prompts of the installation w
4. After the program is installed, a shortcut icon fo
program is displayed on the desktop.

Starting the Management Program
After the USB Slider is installed, the management program is launched
automatically. Then every time the USB Slider is connected to the PC, the
tomatically.
ram and then remove the USB Slider directly.
nagement Program
1. art Menu.
Control Panel.
SB
Slider.
Note:
Before removing the management program, exit the management program.
Version: V100R001_01 Part Number: 31010AEG
management program is launched au
You can also double-click the shortcut icon on the desktop to launch the
management program.
Removing the USB Slider
Exit the management prog
Removing the Ma
Click St
2. Click
3. Click Add/Remove Program to remove the management program of the U