Huawei EG8147X6 Programming manual

1 | P a g e
Huawei GPON
(EG8147X6)
Troubleshooting Manual
Provided by: NAYAtel Access

2 | P a g e
Huawei GPON (with internal router - Wi-Fi 6) Model – EG8147X6
Huawei EG8147X6 is an Optical Network Terminal (ONT) that operates on
GPON technology. This device features
•4-Gigabit Ethernet Ports
•1-POTS Port
•1-RF Video Port
•1-USB Port
•2.4G and 5G Wi-Fi 6 connectivity

3 | P a g e
Back side ports’ sequence on Huawei GPON (EG8147X6) ONT
TEL Port
Telephone Port
LAN 1 - LAN 4
Gigabit Ethernet Ports
USB
USB Port
Power
Input Power Port
ON/OFF
Power ON/OFF Button
CATV
RF TV-Port

4 | P a g e
Light
Status
Indication
Power
Always On
The device is powered on
Off
Power supply is cut off
WLAN
Always On
WLAN function is enabled
Blinks
Data is being transmitted on WLAN port
PON
Always On
In case of any other status, contact NAYAtel Support
LOS
Always Off
LAN1-LAN4
Green Stable
Ethernet connection established
Green Blinking
Data getting transmitted
TEL
Off
Telephone number not configured
Green Stable
Number configured
Green Blinking
Call in progress

5 | P a g e
Configuring Wi-Fi on ONT device
Connect your computer, phone or laptop to any LAN port on your ONT device using an Ethernet
cable or to Wi-Fi network of Huawei ONT. Access ONT web interface by entering the following
IP address on browser.
192.168.18.1
Login into ONT by entering the following credentials
Username: Epuser
Password: userEp
OR
You can enter the password written on the back of device.
Step 1
Go to Advanced>WLAN>WLAN 2.4G Basic Network Settings and set the SSID (Network name).
Enable the SSID by checking the box. Similarly set the SSID for 5G network as well.

6 | P a g e

7 | P a g e
Step 2:
Set the Authentication mode to WPA/WPA2 PreSharedKey and Encryption mode to AES. Set the
Wi-Fi security key (WPA PreSharedKey). Password should be 8 to 63 characters. Repeat the
same process for 5G network settings.

8 | P a g e

9 | P a g e
Step 3:
After setting SSID (network name) and password, click on apply button at the end of setting to
apply and save the changes.
Step 4:
Go to 2.4G Advanced Network Settings. Change the regulatory domain to “Pakistan”, channel to
“Automatic” setting and channel width to “20MHz”. Click on apply button to save the changes.

10 | P a g e