Hubbell 31.130 User manual

Hubbell Industrial Controls, Inc.
Spec Sheet 31.130 • October 2000
Replaces: Catalog Sheet 31132 License-Free Radio
License
Free Radio
Control
Systems
120V AC Single & Two Speed
Hubbell Radio Remote Control Systems
HUBBELL
•System approved for operation
under FCC Part 15 rules —no user license
required.
•Digital FM signal —exceptional immunity to
noise.
•Security —65,000+ address codes
available, user settable by dip switch
•State of the art design —surface mount, micro-
controller electronics.
•Auto power off extends battery life.
•Extremely compact and cost effective systems.
Select one of several single-speed transmitters or
a two-speed transmitter:
•Key-Ring - with 1 or 4 buttons
•Belt-Clip - with 1, 2, 3, 4, or 6 buttons
•Hand-Held - with 6 or 8 buttons
•Hand-Held -- with 8 two-speed buttons.
All transmitters are rated NEMA 3 for indoor/
outdoor use.
Select receivers with the number of output relays
to match the transmitter functions. A flexible
half–wave antenna mounts directly to the
receiver by BNC connector. All receivers are
rated NEMA 4X for indoor/outdoor use.
Eight Relay Receiver
with “Stop”
Single Speed Control
System Features
•Extremely compact and cost effective
Remote Control Systems
•Output relays are individually settable
for momentary or latched function
•Highly reliable and secure operation
•Meets FCC Part 15 rules: no user
license required
Two Speed Control
System Features
•Extremely compact and cost effective
Remote Control Systems
•Output relays are individually settable
for momentary or latched function
•Highly reliable and secure operation
•32 frequencies in the 430 MHz FM
band
•Active E-Stop
•Meets FCC Part 15 rules: no user
license required
Four Relay Receiver with Key Ring
& Belt Clip Transmitter

JPS-100-1M © 2000
Printed in U.S.A.
HUBBELL
50 Edwards Street
Madison, Ohio 44057
[phone]
Fax [phone]
4301 Cheyenne Drive
Archdale, NC 27263
[phone]
Fax [phone]
Hubbell Industrial
Controls, Inc.
a subsidiary of
Hubbell Incorporated
Hubbell Industrial Control Solutions
http://www.hubbell-icd.com/radiocontrols/
16 Relay Receiver with “E–Stop”
Hand Held Two Speed
Transmitter with “E–Stop”
(with optional rubber boot)
Two Speed
Specifcations
Transmitter Specifications
•Built-in antenna
•Digital pulse transmission
•LED to indicate “transmitting/battery low”
•2 LED’s to indicate selected function
•For indoor and outdoor use: NEMA 3 and
IP 54
Hand-Held Transmitter
with “E-Stop”
•Eight 2-speed pushbuttons, push/pull
switch for “E-stop/Run”, key-switch for
transmitter “On/Off”
•Automatic “power off”, user settable for
2, 6, 12 minutes, or manual
•Rechargeable lithium battery
•Operating time: 12 hours continuous
•Recharge time: 11⁄2hours
•Approx. weight: 10 oz. with battery
•Approx. size: 6”x 3”x 11⁄2”
Receiver Specifications
•Double superheterodyne, synthesized
•Sensitivity -110 dBm or better at 20 dB S/N
•1⁄2wave flexible antenna
•Output relays rated 16 Amp at 250V ac
•For indoor and outdoor use: NEMA 4X
and IP 65
•For operation from 120V ac power, or
optionally: 12/24V dc; 12/24V ac
9 Relay Receiver with “E-Stop”
•9 output relays
•2 “E-Stop”relays
•Approx. size: 9”x 6”x 31⁄2”
16 Relay Receiver with “E-Stop”
•16 output relays
•2 “E-Stop”relays
•Approx. size: 12”x 9”x 21⁄2”
Single Speed
Specifcations
Transmitter Specifications
•Built-in antenna
•Frequency: 433 MHz, FM
•Digital pulse transmission
•LED to indicate “transmitting/battery low”
•For indoor and outdoor use: NEMA 3 and
IP 54
Key-Ring Transmitter
•1 or 4 pushbuttons
•12 Volt alkaline battery
•Operating time: 15 hours continuous
•Approx. weight: 1 oz. with battery
•Approx. size: 3”x 1”x 1⁄2”
Belt-Clip Transmitter
•1, 2, 3, 4, or 6 pushbuttons
•9 Volt alkaline battery
•Operating time: 24 hours continuous
•Approx. weight: 4 oz. with battery
•Approx. size: 4”x 21⁄2”x 1”
Hand-Held Transmitter
•6 or 8 pushbuttons
•9 Volt alkaline battery
•Operating time: 15 hours continuous
•Approx. weight: 9 oz. with battery
•Approx. size: 6”x 3”x 11⁄2”
Hand-Held Transmitter
with “Stop”
•4, 6 or 8 pushbuttons, push/pull switch
for “Stop/Run”, key-switch for transmitter
“On/Off”
•Rechargeable lithium battery
•Operating time: 30 hours continuous
•Recharge time: 3 hours
•Approx. weight: 10 oz. with battery
•Approx. size: 6”x 3”x 11⁄2”
Receiver Specifications
•Double superheterodyne
•Sensitivity -110 dBm or better at 20 dB S/N
•Frequency: 433 MHz, FM
•1⁄2 wave flexible antenna
•Output relays rated 8 Amp at 250V ac
•For indoor and outdoor use: NEMA 4X
and IP 65
•For operation from 120V ac power, or
optionally: 12/24V dc; 12/24V ac
4 Relay Receiver
•4 output relays
•Approx. size: 5”x 5”x 2”
4 Relay Receiver with “Stop”
•4 output relays
•1 “stop”relay
•Approx. size: 5”x 5”x 2”
6 Relay Receiver
•6 output relays
•Approx. size: 8”x 5”x 21⁄2”
6 Relay Receiver with “Stop”
•6 output relays
•1 “stop”relay
•Approx. size: 8”x 5”x 21⁄2”
8 Relay Receiver
•8 output relays
•Approx. size: 8”x 5”x 21⁄2”
8 Relay Receiver with “Stop”
•8 output relays
•1 “stop”relay
•Approx. size: 8”x 5”x 21⁄2”