Hunza ULTRA 12 SPOT User manual

REMOTE DRIVEN (SERIES) CONNECTIONS
Make input connections according to diagram below.
DRIVER OUTPUT:
CONSTANT
CURRENT 700mA
Max, 18Vdc
POSITIVE
NEGATIVE
NOTE: THESE INSTRUCTIONS MUST NOT CONTRAVENE YOUR
LOCAL ELECTRICAL AUTHORITY REGULATIONS, WITH WHICH
ALL INSTRUCTIONS HERE IN MUST COMPLY.
PLEASE KEEP INSTRUCTIONS FOR FUTURE REFERENCE.
POSITIVE
NEGATIVE
24VDC INPUT CONNECTIONS
Make input connections according to diagram below.
24VDC CONSTANT
VOLTAGE
(white)
(Black)
120/240V (RETRO) CONNECTIONS
Make input connections according to diagram below.
INPUT: 100-277VAC
(white)
(Black)
INPUT: 100-277VAC
USA
(Green)
(Green)
The Ultra 12 Spot must be specified with a mounting accessory.
ULTRA 12 SPOT
Installation instructions
Follow Diagram opposite to correctly fix
the Bracket to the desired surface.
Fixing screws are provided however
some mediums may require different
fixing hardware. If so please ensure the
fixing hardware is adequate to take the
weight of the fixture.
After the Bracket has been fixed in place
make the input connections. All
connections should be water tight to stop
water ingress into the fixture via power
cables.
See diagrams below for correct wiring
Warning: Do not connect secondary side (output) of a live
driver to the Fixture. This will cause a spike in voltage that
can damage the LED. When connecting or disconnecting
the tting always ensure the 120/240V power supply is
disconnected.
When using a photocell and/or timer we recommend using
devices with relay outputs as opposed to electronic. The
high frequency of electronic devices can lead to failure of
the LED driver.
(Red)
(Black)
(Red)
(Black)

Adjusting Head position.
Use Hex (allen) key provided to
loosen indicated screws to
adjust rotation and head angle.
Once desired postioning is
achieved tighten screws to lock
in place
NOTE: THESE INSTRUCTIONS MUST NOT CONTRAVENE YOUR
LOCAL ELECTRICAL AUTHORITY REGULATIONS, WITH WHICH
ALL INSTRUCTIONS HERE IN MUST COMPLY.
PLEASE KEEP INSTRUCTIONS FOR FUTURE REFERENCE.
Lens
Lens ring
Optic
LED Chip
LED Holder
Gasket
Circlip
LED replacement
Unscrew Lens ring. Remove lens, gasket, circlip and optic. Pay
close attention to component order. Unscrew two M3 screws on
the LED holder. The LED chip can now be changed. Make sure
correct polarity connection is made between LED chip and the
LED holder. Reverse the action to seal luminaire making sure
components are replaced in correct order. Incorrect order can
lead to failure of LED and/or leaking. Please ensure no dirt or grit
is present around lens or gasket.