Hydromatic HV200 Series User manual

HYD1045 (05/15/2021)2
TABLE OF CONTENTS
INTRODUCTION
Safety Instructions .............................................................................................................................................................................. 3
Installation And Operation....................................................................................................................................................................4
Common Parts List

HYD1045 (05/15/2021) 3
SAFETY INSTRUCTIONS
SAFETY SYMBOLS
This is the safety alert symbol. When you see this symbol on your
pump or in this manual, look for one of the following signal words and be
aler t to the potential for personal injur y:

HYD1045 (05/15/2021)4
INSTALLATION AND OPERATION
INSTALLING PUMP IN SUMP

HYD1045 (05/15/2021) 5
INSTALLATION AND OPERATION
PUMP MAINTENANCE
As the motors are oil filled, no lubrication or other maintenance
is required.
If the heat sensor and seal failure are hooked up properly, no
attention is necessary as long as the seal failure indicator light
doesn’t come on. To ensure continuity of the seal sensor leads, a
test light is provided on intrinsically safe Hydromatic® panels as
standard equipment. Pump should be checked every quarter for
corrosion and wear.
If cord openings from sump to control panel are
open, gases from sump could enter panel and an explosive
condition could exist. Seal openings!
REPLACING CORDS:
The power cord and heat sensor/seal failure cord are potted into
the connection box cap, forming the cord and cap assembly.
If cords require replacement due to damage or cords being too
short, cord and cap assembly must be replaced as a complete
assembly from the factory. Check pump for proper rotation
before returning to normal service.

HYD1045 (05/15/2021)6
COMMON PARTS LIST

HYD1045 (05/15/2021) 7
COMMON PARTS LIST
ITEM ENGINEERING NO. DESCRIPTION Q T Y.
1
28139B000 230 V 1 Phase Motor Assembly 1
28139B001 200 V 3 Phase Motor Assembly 1
28139B002 230/460 V 3 Phase Motor Assembly 1
28139B004 575 V 3 Phase Motor Assembly 1
28139B003 200 V 1 Phase Motor Assembly 1
2
28228B000 Imp1s ÒXs Ðsr8521

HYD1045 (05/15/2021)

HYD1045 (05/15/2021)

INTENTIONALLY LEFT LANK

WARRANTY

All indicated Pentair trademarks and logos are property of Pentair. Third party registered and unregistered trademarks and logos are the property of their respective owners.
Because we are continuously improving our products and services, Pentair reserves the right to change specications without prior notice. Pentair is an equal opportunity employer.
MY1045 (05/15/21) ©2021 Pentair. All Rights Reserved.
AMERICAS
1101 Myers Parkway
Ashland, Ohio 44805
PH: 855-274-8947
CANADA
490 Pinebush Road,
Unit 4
Cambridge, Ontario,
Canada N1T 0A5
PH: 800-363-7867
pentair.com