Hypex Electronics Nilai 500 User manual

Getting Started with Your Hypex Nilai 500 Amplifier
(assembled by Deer Creek Audio)
Please take a moment to review the following details on your new Hypex Nilai 500 Amplifier(s), assembled by
Deer Creek Audio.
What's Included
● Assembled amplifier(s)
● Printed test results
● Power cord
● User Instructions
● Assembly manual
● Tool kit
Powering Your Unit On and Off
Your Nilai 500 has three AC power controls
● Master on / off AC switch on the rear panel
● Standby on / off switch on the front panel
● 12 Volt trigger control input
The front switch can be used to turn on and turn off (standby) the power amplifier when the 12 Volt trigger
option is not used (when used, the 12 Volt trigger overrules the front switch).
Cabling Requirements
● Balanced XLR-to-XLR or TRS-to-XLR cables are preferred
● For single-ended RCA sources, use the cable configuration in the following diagram
● Requires a minimum 13 amp, 3-prong power cord

Break-in period
When you first turn on the amplifiers, allow approximately 60 minutes warm-up time before critical listening.
After the amplifiers have broken in for several hours, the starting warm-up time should be approximately 10
minutes.
Input Gain Jumper
The Amplifier Module contains a pin header (J200) with jumper to alter the input gain setting.
Voltage Gain Jumper Settings
Installation
Be sure to install your Hypex Class D amplifier with adequate ventilation. You’ll need at least one inch on top
of the unit, preferably with an open front and rear.
Check out our Tech Blogs, Tech Videos and other Resources on deercreekaudio.com for the latest technology
news and updates.
deercreekaudio.com
[email protected]
720.726.9272