i-onik PB-5000 User manual

23456
Please read the users‘ manual before
use it.
Brief Introduction
i.onik®PB-5000 is a high capacity
backup power pack which is especially
designed for mobiles, tablets and other
digital products. With built-in iPod 30
pin and micro charging cable, it’s able
to charge two mobiles simultaneously.
Fashionable LED power screen shows
power level anytime. i.onik®PB-5000
could provide extra power whenever
your devices need and wherever you
may be. This is i.onik®PB-5000, your
best charging assistant, your best
friend.
1) Main
2) iPod output
3) Power switch
4) Power indicator
5) Micro output
6) Micro input
Cable disassembling
Please pull out iPhone and micro
connector by ngernail.
Instruction
1. How to charge built-in battery of
i.onik® PB-5000
Connect micro USB cable with i.onik®
PB-5000 and PC (or USB charger),
i.onik®PB-5000 gets charged automa-
tically. Power indicators come on when
charging and all lights are ashing
when fully charged.
2. How to check power level of
built-in battery
Gently press power switch to turn on
power indicator‘s screen, each light
accounts for 25 % power, 4 lights come
on stands for full power. To save power,
indicators screen turns off automatically
within 5 sec.
3. How to use i.onik® PB-5000 to
charge your devices (refer to
picture on the right)
Connect your devices to built-in iPod
30 pin or micro cable (available to charge
two devices together), keep pressing
power switch for 1 sec to turn it on (the
same way to turn it off). LED indicator
comes on when power switch was
pressed and turn off within 5 sec to
save power. To avoid over-charge,
i.onik®PB-5000 turns off automatically
when your devices have been fully
charged.
Notice:
1) Not used for a long time or use for
rst time, you are suggested to use
provided cable.
2) Keep i.onik®PB-5000 at a place
where air ows while charging.
Product features
• Standard USB input, compatible for
all USB chargers.
• Available to charge two devices
simultaneously.
• Built-in battery with 5000 mAh high
capacity.
• Fashionable LED power screen.
• Multi-functional design makes i.onik®
PB-5000 easy to carry and convenient
to use.
• High charging efciency make it 92 %
at least.
Notice:
1) Please use provided micro USB cable
or branded cable to charge i.onik®PB-
5000.
2) Please disconnect charging cable
after fully charged otherwise it might
reduce battery’s life.
3) Do not use any defective chargers.
4) Do not put this product into or near
re to avoid explosion.
5) Please hold the product and get out
plug of cable by ngernail, please do
not pull cable directly.

mobile
PB-5000
Powerbank
User Manual
7 8 9 10
Specications Accessories
Battery type: Li-thium
Battery Capacity: 3.7 V/5000 mAh
Input: DC 5 V/1 A
Output: iPhone: 5 V/1 A
Micro: 5 V/1 A
Dimension: 83 x 50 x 21 mm
Weight: Approx 130 g
Charging time: Approx 6 h
(5 V/1 A charger)
Standby Time: up to 780 h
Talk Time: 3G: 18 h
2G: 36 h
Internet Surng: 3G: 15 h
WLAN: 26 h
Audio Play: up to 100 h
Video Play: up to 26 h
Power Indicators
don’t ash when
charging i.onik®
PB-5000.
Please make sure
if USB charging
cable and power
source are con-
nected correctly.
i.onik®PB-5000
does not charge
devices after
connected.
Please make sure
if USB cable is
connected
correctly.
Power Indicators
don’t ash after
being pressed.
i.onik®PB-5000
has probably run
out of power,
please charge it
in time.
It takes too long
to fully charge
i.onik®PB-5000.
Please use provi-
ded or branded
5 V/1 A charger.
Care and Maintenance
Your device is a product of superior
design and craftsmanship and should
be treated with care. The following
suggestions will help you protect your
warranty.
1) Keep the device dry. Rain, humidity
and all types of liquids or moisture
which contain minerals that will corrode
electronic circuits. If the device does
get wet, turn it completely dry.
2) Do not use or store the device in
dust and wet conditions that would
destroy its moving parts and electronic
components.
3) Do not store the device in hot areas.
High temperatures can shorten the life
of electronic devices, damage batteries,
and warp or melt.
4) Do not store the device in cold areas.
When the device temperature rises to
its normal temperature, moisture can
form inside and damage the circuit
board.
5) Do not drop, knock or shake the
device. Rough handling can break its
sophisticated structure.
6) Do not use harsh chemicals, cleaning
solvents or strong detergents to clean
the equipment.
7) Do not paint the device. Paint will
block the moving parts, thus will affect
the normal operation.
8) If the product does not work, take
it to your nearest authorized service
facility for service.
Service: [phone]*
Email: [email protected]
* € 0,14/min. For calls from mobile phones,
the price may vary.
Optional accessories Standard accessories
QAC Charger Micro USB cable
FAQs
mobile
Chips and More GmbH
Gewerbestr. 7 | 79112 Freiburg | Germany
www.i-onik.de