1 - 2
User Manual
05
06
Example of how the anchor system works.
IMPORTANT: If you are using an electric
screwdriver, adjust the force to avoid damaging
the anchor system.
Using a very fine-tipped screwdriver, remove
the covers that protect the anchor system.
Make sure that the tab of anchor A is inside
the profile frame. If not, use a Phillips head
screwdriver and turn the screw in the anchor
system until the anchor tab is inside the profile
frame.
Insert the profile frame as shown in fig. 7.
INSTALLATION IN PARTITION
First insert the power cable and make the
connections.
User Manual
01
02
04
03
DESK INSTALLATION
Make a cut in the table respecting the tolerances
shown in fig. 1
The Intro profile frame can be installed in desks
between 8 mm and 31 mm thick.
Using a Phillips head screwdriver, tighten the
two anchor screws until they are tight enough
to prevent movement.
If the tabs do not come out, turn the screw in
the other direction and repeat the operation in
the other direction.
Insert the power cable first and then insert the
profile frame as shown in fig. 3.
IMPORTANT: Using a very fine-tipped
screwdriver, remove the covers that protect the
anchor system.
Make sure that the tab of anchor A is inside
the profile frame. If not, use a Phillips head
screwdriver and turn the screw in the anchor
system until the anchor tab is inside the profile
frame.
Now just put on the cover that hides the anchor
system.
For any questions on the profile frame, contact
us at:
TightenLoosen
1
2
08
07
