IBM LC921 User manual

IBM
Power System LC921
(9006-12P) Quick Install
Guide IBM
IBM®Power®System LC921 (9006-12P) Quick Install Guide
The IBM Knowledge Center is available online from: http://www.ibm.com/support/knowledgecenter/
POWER9/p9hdx/9006_12p_landing.htm.
vRead all precautions and instructions before you start working on key parts.
vUse normal electrostatic discharge (ESD) procedures when working on the system and parts. IBM
recommends wearing gloves and an anti-static wrist strap to avoid possible damage to the equipment.
9006-12P parts
Figure 1. Rack final assembly

Figure 2. System parts
2

Rear ports
Figure 3. Additional system parts
3

Table 1. Input and output ports
Identifier Description
1 USB 2.0 used for keyboard and mouse.
Certain USB drives might be too wide to fit properly into
the USB ports on the rear of the system. Test the fit of
your USB drive before proceeding.
2 Ethernet Intelligent Platform Management Interface
(IPMI)
3 Serial IPMI
4 Video Graphics Array (VGA) used for monitor. Only the
1024 x 768 at 60 Hz VGA setting is supported. Only up
to a 3-meter cable is supported. Only text-based
capability is supported.
Installing and Removing
Figure 5. Removing a power supply from the system
Figure 6. Releasing and opening the cover
Figure 4. Rear ports
4

Figure 7. Removing a front drive Figure 8. Removing the 3.5-inch drive from the tray
Figure 9. Removing a DOM
Figure 10. Removing the disk drive backplane and screws
5

Figure 11. Removing the fan holder
Figure 12. Removing a fan
Figure 13. Disconnecting the fan cable
Figure 14. Aligning the fan holder
6

Figure 15. Removing the memory DIMM
Figure 16. Two-processor memory plugging sequence
Figure 17. 9006-12P PCIe adapter positions
Figure 18. Removing the PCIe riser
7

Figure 19. Removing the UIO Network screws
Figure 20. Removing a PCIe adapter from position 3 of
the riser
Figure 21. Removing a PCIe adapter from position 2 or 3
of the riser Figure 22. Removing the PCIe riser cards from the PCIe
adapter cage
8

Figure 23. Removing the processor socket screws from
the bottom of the chassis
Figure 24. Screw locations
Figure 25. Lifting out the system backplane
Figure 26. Loosening the load arm screw of the heat sink
9

Figure 27. Removing the heat sink
Figure 28. Locking the system processor module into the
tool
Figure 29. Installing the system processor module
Figure 30. Removing the system processor module tool
10