IBM Power System LC922 User manual

IBM
Power System LC922
(9006-22P) Quick Install
Guide IBM
IBM®Power®System LC922 (9006-22P) Quick Install Guide
The IBM Knowledge Center is available online from: http://www.ibm.com/support/knowledgecenter/
POWER9/p9hdx/9006_22p_landing.htm.
vRead all precautions and instructions before you start working on key parts.
vUse normal electrostatic discharge (ESD) procedures when working on the system and parts. IBM
recommends wearing gloves and an anti-static wrist strap to avoid possible damage to the equipment.
9006-22P parts
Figure 1. Rack final assembly

Rear ports
Figure 2. System parts
2

Table 1. Input and output ports
Identifier Description
1 USB 2.0 used for keyboard and mouse.
Certain USB drives might be too wide to fit properly into
the USB ports on the rear of the system. Test the fit of
your USB drive before proceeding.
2 Ethernet Intelligent Platform Management Interface
(IPMI)
3 Serial IPMI
4 Video Graphics Array (VGA) used for monitor. Only the
1024 x 768 at 60 Hz VGA setting is supported. Only up
to a 3-meter cable is supported. Only text-based
capability is supported.
Installing and Removing
Figure 4. Removing a power supply from the system
Figure 5. Releasing and opening the cover
Figure 3. Rear ports
3

Figure 6. Removing a front drive Figure 7. Removing the 3.5-inch drive from the tray
Figure 8. Removing a DOM
Figure 9. Removing a rear drive
4

Figure 10. Opening the rear drive tray
Figure 11. Disconnecting the drive signal cables the drive
power cables
Figure 12. Removing the disk drive backplane and screws
Figure 13. Disconnecting the drive signal cables the drive
power cables from the system backplane
5

Figure 14. Disconnecting the drive signal cables and the
drive power cables from the disk drive backplane
Figure 15. Removing a fan
Figure 16. Removing the memory DIMM
Figure 17. Single-processor plugging sequence
Figure 18. 9006-22P PCIe adapter positions
Figure 19. Removing the PCIe riser
6

Figure 20. Removing an adapter in position 1 from the
riser Figure 21. Removing a position 2 adapter from the riser
Figure 22. Removing position 1 riser card
Figure 23. Removing the PCIe riser Figure 24. Removing an adapter from the riser
7

Figure 25. Removing position 3, 5, or 6 riser card
Figure 26. Releasing the tail-stock
Figure 27. Screw locations Figure 28. Lifting out the system backplane
8

Figure 29. Opening the system processor module
packaging
Figure 30. Loosening the load arm screw of the heat sink
Figure 31. Lifting the heat sink from the load arm Figure 32. Lowering the removal tool onto the system
processor module
9

Figure 33. Locking the system processor module into the
tool
Figure 34. Lifting the system processor module from the
packaging tray
Figure 35. Installing the system processor module Figure 36. Installing the heat sink
10