Icera iWash CS-22 Operation manual

iWash CS-22
Integrated Bidet Toilet
Installation & User Guide
THIS PRODUCT WILL NOT FUNCTION IF PROVIDED ANGLE STOP AND SUPPLY LINE

1
READ ALL INSTRUCTIONS BEFORE USE
1. Do not use while bathing.
2. Do not place or store appliance where it can fall or be pulled into a tub or sink.
3. Do not place in or drop into water or any other liquid.
4. If an appliance falls in water, unplug it immediately. Do not reach into the water.
1. Close supervision is necessary when this appliance is used by, on or near children
or handicapped persons.
2. Use this appliance only for its intended use as described in this manual. Do not use any
3. Never operate this appliance if it has a damaged cord or plug, if it is not working
properly, or if it has been dropped, damaged, or dropper into water. Contact Icera
4. Keep the cord away from heated surfaces. Do not wrap the cord around the appliance.
as a bed or couch, where the air openings may be blocked. Keep the air openings free of
lint, hair and other debris.
6. Never drop or insert any object into any opening or hose.
7. Do not use outdoors or operate where aerosol (spray) products are being used or where
oxygen is being administered.
8. Do not use an extension cord with this appliance.
9. Use this appliance only for household use.
further details.
IMPORTANT SAFETY INSTRUCTIONS

2
LISEZ TOUTES LES INSTRUCTIONS AVANT UTILISATION
baignoire ou un evier.
3. Ne pas placer dans ou tomber dans l'eau ou tout autre liquide.
dans l'eau.
proximite d'enfants ou d'invalides.
pas correctement, ou s'il a ete echappe, endommage ou tombe dans l'eau. Contactez le
l'appareil.
5. Ne bloquez jamais les ouvertures d'air de l'appareil et ne le placez pas sur une surface
molle, comme un lit ou un canape, ou les ouvertures d'air peuvent etre bloquees. Gardez
les ouvertures d'air exemptes de peluches, cheveux et autres debris.
6. Ne laissez jamais tomber ou n'inserez aucun objet dans une ouverture ou un tuyau.
ou ou de l'oxygene est administre.
10. Connectez ce produit a une prise correctement mise a la terre uniquement. Voir les
CONSIGNES DE SECURITE IMPORTANTES

3
SAFETY PRECAUTIONS
DANGER
CAUTION
PROHIBITED
OBSERVE
STRICTLY
DANGER
Doing so may Doing so may cause an electrical
shock.
Plugging too many
plugs into the same outlet, for example by using
. Failure to do so may cause a

4
SAFETY PRECAUTIONS
DANGER
Doing so
in injury or water damage.
Failure to do so
could cause electrical shock. This does not apply
Do not strike, yank,
twist, bend, damage heat or otherwise alter the
power cords. Do not place anything heavy, bind or
pinch the power cords. Using a damaged power
short.
Do
not use any of the following:
Toilet cleaner, household cleaner, benzene, paint
thinner, powdered cleanser or nylon scrubbing
pads.
These items could damage the water supply hose
and cause a water leak.
short.
heat.
Doing so could cause
an electrical shock.
Doing so
Failure to install a
grounded outlet could cause electrical shock in
DO NOT
SPRAY WATER
PROHIBITED
PROHIBITED
OBSERVE
STRICTLY
OBSERVE
STRICTLY
OBSERVE
STRICTLY

5
SAFETY PRECAUTIONS
DANGER
Improper use of a heated seat could cause a low-grade burn. When
burns or equipment damage.
• Young children, elderly persons or other uses unable to set the temperature appropriately
themselves.
• The ill, physically disabled or other persons who do not have freedom of movement.

6
SAFETY PRECAUTIONS
CAUTION
Doing so may
cause injury or product damage.
Doing so may cause product
Do not drape clothes or linens or otherwise block the warm air outlet.
• Water is leaking from a pipe or from the main unit.
• The product is making a strange noise or emits a strange odor.
• The product emits smoke.
• The product is abnormally hot .
This may cause damage to the mechanism.
Doing so could
Doing so could cause water leaks.
Doing so could cause the main unit to
PROHIBITED PROHIBITED
OBSERVE
STRICTLY
OBSERVE
STRICTLY

7
GROUNDING INSTRUCTIONS &
In the event of an electrical short circuit, grounding reduces
the risk of electric shock. The plug must be plugged into an outlet that is properly installed and
grounded.
DANGER Improper use of the grounding plug can result in electric shock.
understood, or if in doubt as to whether the product is properly grounded.
the proper electric circuit. Make sure that the product is connected to an outlet having the same
This product is for use on a nominal 120V circuit and a GFCI (ground fault circuit interrupter)
with an ungrounded outlet.
Do not use an extension cord with this product. Do not use an adapter with this product. Do not
If repair or replacement of the cord or plug is necessary, do not plug into an outlet. Contact Icera’s
Customer Service department to discuss possible repair or replacement.

8
FREQUENCY INTERFERENCE
responsible for compliance could void the user’s authority to operate the equipment.
Note: This equipment has been tested and found to comply with the limits for a Class B digital
device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable
uses and can radiate radio frequency energy and, if not istalled and used in accordance with the
between the equipment and receiver, (3) connect the equipment into an outlet on a circuit
pas produire de brouillage; (2) l’appareil doit accepter tout brouillage radioélectrique subi, même si

9
INSTALLATION INSTRUCTIONS
• Make sure all accessory parts are present.
•
•
only.
• Water pressure must be 50 - 116 PSI.
•
•
performance of the product.
• In low temperature environments, please leave the product in a warm room
internal parts.
•
clearance space is available. The distance of the water inlet pipe to the ground
should be no more than 150mm.
•

10
INSTALLATION INSTRUCTIONS
3. Seperate the
electronic seat
with the ceramic
by holding the
upper cover with
both hands, and


the back, loosen the braided
tube and wires.


bolts.

gaskets,nuts on the bolts in



7.Reinstall the braided tube
as in step 4 and connect the
wires.
8.
cover, align it with the 4 holes


nuts
plas�c
gasket
metal
gasket

11
ONLY THE ANGLE STOP AND SUPPLY LINE
INSTALLATION INSTRUCTIONS

12
INSTALLATION INSTRUCTIONS

13
FRAGRANCE INSTRUCTIONS
PRECAUTIONS
INSTALLATION

14
iWASH CS-22 FEATURES & REMOTE GUIDE
TEXT
Pantone
Cool Gray 11 C
LED CUT
Black
0, 0, 0,100
TOP
DECAL
BACKGROUND
SILVER
FRONT
DECAL
BACKGROUND
Pure White
INLAY - TOP
INLAY - FRONT
INLAY - TOP
INLAY - FRONT
Press and hold for
3 sec. for STANDBY
mode. While the
unit is on, press
once quickly to
Press to start the
dryer cycle.
With the seat unoccupied, press
water pressure and temp. to desired
Press once to
cycle and dryer
cycle.
Press the up arrow
to move the nozzle
forward or the
down arrow to
move the nozzle
backwards during
the rear or front
wash cycles.
Press quickly to start
cannot be used
when the seat is in
cleaning mode.
Press once to
wash cycle. While
press again to
down arrows to
the fragrance
down arrows to
control the seat
temperature.
Choose from 4
levels.
Press quickly to
turn the nightlight
hold to start or exit
down arrows to
control the water
temperature.
Choose from 4
levels.
Press quickly
to open or
close the seat
lid. Press and
hold to turn
the auto-open
down arrows to
control the water
pressure. Choose
from 5 levels.
Press quickly to raise
or lower the seat.
Press and hold to
turn the auto-open
LED light bar will indicate the
selected temp, pressure or air
freshener levels.
If the lightning icon is lit,
your remote.
Press once to
front wash cycle.
While front cycle

15
iWASH CS-22 BUTTON GUIDE
bowl. Please see the below diagram for more details.
Contact Icera Customer Service at 855-444-2372 or [email protected], if a replacement remote
is needed.
Foot sensing flush
Press
manually
in the
event of
a power
outage.
Press to
complete
rear wash cycle,
LED light will be blue
during wash, dry
and nozzle cleaning
cycles. It will be blue
in all other modes.

16
CLEANING YOUR iWASH
AND
•
•
both ends of the hose.
•
•
wall angle stop counterclockwise.
•
area before using. Do not use toluene, mineral oil, heptane and nitric, chromic or sulfu-
ric acids to clean this product.
• Unplug before cleaning. Do not splash water on the plug or outlet.
•
• Do not spray water onto the unit.
•
•
• Do not pull the nozzle out or exert force while cleaning. This may cause product
damage.
•
•
•
•
CLEANING THE WATER FILTER
EXTERNAL CLEANING
CLEANING THE BIDET NOZZLE

17
TROUBLESHOOTING GUIDE
ISSUE POSSIBLE CAUSES SOLUTION
Seat does not work at all.
The seat sensor is covered by cloth
or any other object. Sensor must be
Remove any fabric or object blocking
the seat sensor.
Make sure the plug is securely
plugged into the outlet.
or side panel to turn the unit back on.
Power is out. This seat is fully electronic. Power
must be on in order for seat to work.
working.
Filter is clogged.
Spray pressure is not
strong enough.
Water pressure is set at lowest level. Increase the water pressure using the
remote control.
Filter is clogged.
Nozzle is clogged or dirty. Clean the nozzle. See page 15 for
Spray is not warm
enough.
Water temperature is set at lowest
level.
Increase the water temperature using
the remote control.
Seat is not warm. Seat temperature is set at lowest
level.
Increase the seat temperature using
the remote control.
Remote control is not
working.
incorrectly. correctly and test. Replace if
necessary.
Seat is unoccupied.
the seat is unoccupied. Make sure
the seat sensor is being engaged.
Remote is not properly paired with
the seat.
See page 17 for remote pairing

18
PAIRING YOUR REMOTE
•
•
•
• Check your remote. If the 4th and 5th indicator lights under the Icera logo
on your remote are lit, you have successfully paired your remote with your
bidet seat.
•
• Please email [email protected] if you are unable to pair your remote
with your seat.