Icom IC-F3002 User manual

A6798D-8EU Printed in Japan
© 2017 Icom Inc.
1-1-32 Kamiminami, Hirano-ku, Osaka 547-0003, Japan
- 1 -
Thank you for choosing this Icom product.
READ ALL INSTRUCTIONS carefully and completely
before using this product.
This instruction sheet includes some functions that are
usable only when they are preset by your dealer. The
transceiver may have other functions and operations that
are not described in this instruction sheet. Ask your dealer
for preset function details.
DBATTERY PACK
Battery pack Voltage Capacity Battery life *1
BP-263 Battery case for
AA (LR6) × 6 alkaline —*2
BP-264 7.2 V
1400 mAh
(minimum)
1420 mAh
(typical)
VHF 14.1
hours
UHF 13.7
hours
BP-265 7.4 V
1900 mAh
(minimum)
2000 mAh
(typical)
VHF 20.2
hours
UHF 19.6
hours
*1When the power save function is turned ON, and the operating
time is calculated under the following conditions.
TX : RX : Standby = 5 : 5 : 90
*2The average operating time depends on the alkaline cells.
DCHARGERS
• BC-191 desktop charger + BC-123S ac adapter
For rapid charging of the Ni-MH battery pack. A power
adapter may be supplied with the charger, depending on
the version.
Charging time: Approximately 2 hours for the BP-264.
• BC-192 desktop charger + BC-206S ac adapter
For regular charging of the Ni-MH battery pack. A power
adapter may be supplied with the charger, depending on
the version.
Charging time: Approximately 16 hours for the BP-264.
• BC-193 desktop charger + BC-123S ac adapter
For rapid charging of the Li-ion battery pack. A power
adapter may be supplied with the charger, depending on
the version.
Charging time: Approximately 2.5 hours for the BP-265.
• BC-197 multi-charger
For rapid simultaneous charging of up to 6 battery packs.
A power adapter may be supplied with the charger,
depending on the version. There are 2 types of the
BC-197 chargers for the IC-F3002 and the IC-F4002.
BC-197
Charger Type
Chargeable
Battery Charging time
With AD-120* BP-264
Ni-MH battery
Approximately
2 hours
With AD-121* BP-265
Li-ion battery
Approximately
2.5 hours
* Either the AD-120 or the AD-121 charger adapters are
installed in the BC-197, depending on the chargeable
battery pack.
DDC POWER CABLES
• CP-23L cigarette lighter cable
Enables charging of the battery pack through a 12 V
cigarette lighter socket. (For the BC-191/BC-193)
• OPC-515L dc power cable
Enables charging of the battery pack using a power
source instead of a power adapter.
DBELT CLIPS
• MB-124 belt clip
Exclusive alligator-type belt clip
DANTENNAS
• FA-SC73US/FA-SC56VS/FA-SC57VS stubby antennas
FA-SC73US: 450 ~ 490 MHz
FA-SC56VS: 150 ~ 162 MHz
FA-SC57VS: 160 ~ 174 MHz
• FA-SC25U/FA-SC57U/FA-SC72U/ FA-SC25V/FA-SC55V
antennas
FA-SC25U: 400 ~ 430 MHz
FA-SC57U: 430 ~ 470 MHz
FA-SC72U: 470 ~ 520 MHz
FA-SC25V: 136 ~ 155 MHz
FA-SC55V: 146 ~ 174 MHz
• FA-SC61VC/FA-SC61UC cut antennas
FA-SC61VC: 136 ~ 174 MHz
FA-SC61UC: 380 ~ 520 MHz
DOTHER OPTIONS
• AD-98FSC antenna connector converter
Enables you to connect an external antenna with a BNC
connector.
• HM-158L/HM-159L speaker-microphone
Combination speaker-microphone that provides
convenient operation while hanging the transceiver on
your belt.
• HS-94/HS-95/HS-97 headset + OPC-2004 plug adapter
cable
HS-94: Ear hook type
HS-95: Neck-arm type
HS-97: Throat microphone
OPC-2004: Enables you to connect the HS-94/HS-95/
HS-97 to the transceiver. After connecting,
you can use the VOX function.
Some options may not be available in some countries.
Ask your dealer for details.
Icom, Icom Inc. and the Icom logo are registered trademarks of Icom
Incorporated (Japan) in Japan, the United States, the United Kingdom,
Germany, France, Spain, Russia, Australia, New Zealand, and/or other
countries.
- 4 -
* Dealer assignable
INSTRUCTIONS
VHF TRANSCEIVER
Iç-F3002
UHF TRANSCEIVER
Iç-F4002
IMPORTANT SUPPLIED ACCESSORIES
Flexible antennaBattery pack
Belt clip
Jack cover
(with screws)
Battery charger
Power adapter
PANEL DESCRIPTION
MICROPHONE
SPEAKER
[Lower]*
[Upper]*
[PTT]
ANTENNA
CONNECTOR
ROTARY
SELECTOR
STATUS
INDICATOR
[VOL]
SPEAKER-
MICROPHONE
JACK
DAbout the Status indicator
•Lights red* while transmitting.
* When the optional battery case is attached, the Status indicator
lights orange.
•Lights green while receiving a signal, or when the squelch
is open.
•Lights or blinks orange when a matching 2-Tone or 5-Tone
code is received, depending on the presetting.
DAbout the speaker-microphone jack
Connect the optional speaker-microphone or VOX adapter
cable.
Jack cover
DAbout the assignable key functions
Your dealers can assign some functions to [Upper] and
[Lower]. Ask your dealer for preset function details.
NOTE: Attach the jack cover
when optional equipment is not
used.
OPTIONS
NOTE:
Some accessories are not supplied, or the shape is
different, depending on the transceiver version.

- 2 - - 3 -
DTurning ON the transceiver
NOTE: Before using the transceiver for the rst time, the
battery pack must be fully charged for optimum life and
operation. See the BATTERY CHARGING section of this
sheet.
Rotate [VOL] to turn ON the transceiver.
DReceiving and Transmitting
Receiving:
1. Select a channel.
LRotate [ROTARY SELECTOR], or push one of the Memory
channel keys, [MR-CH 1] to [MR-CH 4], to select a channel.
2. When receiving a call, rotate [VOL] to adjust the audio
output level to a comfortable listening level.
Transmitting:
CAUTION: Attach an antenna before transmitting.
Transmitting without an antenna may damage the
transceiver.
1. Wait until the channel is clear to avoid interference.
2. Hold down [PTT] to transmit.
3. Release [PTT] to receive.
IMPORTANT:
To maximize the readability of your signal:
1. After pushing [PTT], pause briey before you start
speaking.
2. Hold the microphone 5 to 10 cm (2 to 4 inches) from
your mouth, then speak at your normal voice level.
BASIC OPERATION
BATTERY CHARGING
DUsing the BC-191 to rapidly charge the
BP-264
The BC-191 rapidly charges the BP-264 ni-mh battery pack.
LCharging time for the BP-264: Approximately 2 hours
A power adapter (not supplied with some versions) or the
OPC-515L dc power cable/ CP-23L cigarette lighter cable
is
additionally required.
CAUTION: NEVER connect the OPC-515L to a power
source using reverse polarity. This will ruin the battery
charger. (White line: +,Black line: _)
Screws:
User supplied self tapping screw (M3.5 × at least 30 mm).
Using screws to secure the charger is recommended.
Charge indicator:
• Lights orange: While charging
• Lights green: Charging completed
DUsing the BC-192 to regularly charge
the BP-264
The BC-192 regularly charges the BP-264 ni-mh battery
pack.
LCharging time for the BP-264: Approximately 16 hours
(at 16 V)
A power adapter (not supplied with some versions) or the
OPC-515L dc power cable is additionally required.
CAUTION: NEVER connect the OPC-515L to a power
source using reverse polarity. This will ruin the battery
charger. (White line: +,Black line: _)
Screws:
User supplied self tapping screw (M3.5 × at least 30 mm).
Using screws to secure the charger is recommended.
Charge indicator: Lights green while charging.
LThe charge indicator will not go out even after a battery
pack is fully charged.
Turn OFF
BATTERY CHARGING (Continued)
The BC-193 can rapidly charge the BP-265 li-ion battery
pack.
LCharging time for the BP-265: Approximately 2.5 hours
A power adapter (not supplied with some versions) or the
OPC-515L dc power cable/ CP-23L cigarette lighter cable
is
additionally required.
CAUTION: NEVER connect the OPC-515L to a power
source using reverse polarity. This will ruin the battery
charger. (White line: +,Black line: _)
Screws:
User supplied self tapping screw (M3.5 × at least 30 mm)
Using screws to secure the charger is recommended.
Charge indicator:
• Lights orange: While charging
• Lights green: Charging completed
The BC-197 can rapidly charge up to 6 battery packs.
LCharging time for the BP-264: Approximately 2 hours
LCharging time for the BP-265: Approximately 2.5 hours
A power adapter (not supplied with some versions) or the
OPC-656 dc power cable is additionally required.
CAUTION: NEVER connect the OPC-656 to a power
source using reverse polarity. This will ruin the battery
charger. (Red line: +,Black line: _)
Charge indicator:
Each indicator functions independently.
• Lights orange: While charging
• Lights green: Charging completed
Charger adapter:
There are 2 types for the IC-F3002 and the IC-F4002. One
is for Ni-MH batteries, and the other is for Li-ion batteries.
BE SURE to choose the suitable charger type. See the
OPTION section on page 4 of this sheet.
Battery pack Transceiver
+ battery pack
Screws
Charge indicator
Power adapter
(A different type, or no power adapter is supplied,
depending on the charger version.)
The optional OPC-515L
(for a DC power source)
or the CP-23L (for a
12 V cigarette lighter
socket) can be used
instead of the power
adapter.
To an
AC outlet
Charge indicator
Power adapter
(A different type, or no power adapter is supplied,
depending on the charger version.)
Battery pack Transceiver
+ battery pack
The optional OPC-515L
(for a DC power source)
can be used instead of
the power adapter.
Turn OFF
To an
AC outlet
Power adapter
(A different type, or no power adapter is supplied,
depending on the charger version.)
Battery pack Transceiver
+ battery pack
Screws
Charge indicator
The optional OPC-515L
(for a DC power source)
or the CP-23L (for a
12 V cigarette lighter
socket) can be used
instead of the power
adapter.
Turn OFF
To an
AC outlet
Charge indicator
Charger adapter
To an
AC outlet
Power adapter
(A different type, or no
power adapter is supplied,
depending on the charger
version.)
OPC-656
(Connect to a DC power
source: 12 ~ 16 V, at least 7 A)
Turn OFF
Battery pack
Transceiver
+ battery pack
DUsing the BC-193 to rapidly charge the BP-265
DUsing the BC-197 to rapidly charge the BP-264 or BP-265