WEARING INSTRUCTIONS AND ADJUSTMENT:
Repeat for each boot: Release the adjustment tab on the top inside of the boot. To do this, grasp the tab then pull it away from the calf,
releasing the hook and loop fastener. Unzip zipper on inside of boot by pulling zipper pull down. Insert foot, pulling the boot on. Slide foot
all the way down in the boot. Confirm boot fit. Boot should feel snug on foot but not too tight. Foot should be the same length as the boot
without being too much shorter or too much longer than the boot. Zip boot by pulling zipper pull up. Confirm that no pant, sock, or other
material is caught in the zipper preventing it from closing completely. Next, reengage the adjustment tab. Grasp the tab and pull rearwards
and then press the adjustment tab against the inside of the leg, reengaging the hook and loop fastener. Be sure to confirm that no pants,
sock, or other material is caught in the hook and loop fastener. The fit of the boot, at the top, may be adjusted by releasing the adjustment
tab as above and then repositioning the adjustment tab and reengaging the hook and loop fastener as above, with the adjustment tab in a
different position. Be sure that the boot is snug enough to stay on the foot but not so tight that it impairs blood circulation or the range of
motion of your foot. Check to confirm that wearing these boots does not reduce your ability to operate the motorcycle controls.
For maximum protection and safety the protective footwear should not cause any discomfort and should not reduce the rider’s freedom
of movement or restrict the reach to, or operation of, the motorcycle controls while in a normal riding position. If you are unable to find a
proper fit in this protective footwear style, please try another CE certified protective footwear style.
SAFETY WARNINGS
SAFETY INSPECTIONS AND OBSOLESCENCE
BEFORE EVERY USE:
Check the soles of the boots to confirm that they are in good condition and attached securely to the boots. Check the linings to confirm
that they are not ripped or torn. Check uppers to confirm that they are not cut, torn, cracked or worn. Check to confirm that the BOA®
lacing system is functioning correctly. Protective footwear that is improperly fastened cannot protect the user. If the protective footwear
or any parts of them become worn, replace the footwear immediately.
IN THE EVENT OF AN IMPACT OR ACCIDENT:
In the event of an impact or accident, the key elements of the protective footwear may become compromised and the protective foot-
wear may no longer provide the limited protection against the forces described in the “Use Restrictions and Limitations” section, and
the “Performance” and “Protection Limitations” sections. The damage may not be visible to the naked eye. In all cases of impact or
accident, replace the boots. Replacement TUSCADERO CE Boots can be purchased at Icon® retail locations.
2 YEAR RULE:
In general, lightweight PPE such as the TUSCADERO CE Boots should be replaced at least every 2 years even if the PPE has not suf-
fered any damage. Damage may be present and may not always be identified by a simple visual inspection.
