ICP DAS USA ET-7200 Series User manual

PET-7200/ET-7200
Quick Start
V1.2, March 2018
Supported Products
ET-7200 Series
ET-7200-UT Series
PET-7200 Series
Technical Support
PET-7200 / ET-7200 User Manual
http://ftp.icpdas.com/pub/cd/6000cd/napdos/et7000_et7200/document/
What’s in the Box?
PET-7200/ET-7200 Module Quick Start
1Factory Default Settings
Network
Connection Default Authentication Default
IP Address: 192.168.255.1 User name: Admin
Subnet Mask: 255.255.0.0 Password: Admin
Gateway: 192.168.0.1
P1
Technical Support: se[email protected]

2Connecting to Network, Computer and Power
Switch
+12 ~ 48 VDC
Power Supply
Non-PoE
PoE
PoE Switch
+12 ~ 48 VDC Power Supply
3-1Assigning a Valid IP Address - Method 1
1) Install eSearch from
http://ftp.icpdas.com/pub/cd/6000cd/napdos/software/esearch/
2) Launch eSearch and click “Search Server”





P2
Technical Support: se[email protected]

3) Double-click the name for your module on the list
Technical Support: se[email protected] P3

4) Enter the network configuration and click “OK”
5) Repeat Step 2. to search the module again
To make sure your modifications take effect.
3-2Assigning a Valid IP Address - Method 2
1) Set the IP configuration on your computer
The ET-7200 module comes with the default IP address of
192.168.255.1, you must chose an IP address for the computer in
the range of 192.168.255.2 – 192.168.255.253 that is not in use.

2) Launch your web browser to go to the ET-7200 web interface
Enter the factory default IP address 192.168.255.1 for the
ET-7200 as the URL in browser and press Enter.


3) Fill out the User name and Password
Fill out the factory default user name and password “Admin” and
then click “OK”.
4) Assign a valid IP address for your ET-7200 module
1. Click “Configuration”
2. Click “Network Settings” in the sub-menu
3. Enter a valid IP address for your ET-7200 module.
4. Click the “SUBMIT” button.


5) Restore the original IP address to your computer



4Logging in to the ET-7200 Module
1) Enter the new IP for the ET-7200 as the URL in browser
2) Fill out the User name and Password “Admin” again
3) Welcome to ET-7200 web site
P4
Technical Support: se[email protected]