IDEAL Touch Logic Combi C User manual

8. Hold the thermostat
approximately 2
metres away from
the boiler and
“CONNECTING TO
BOILER” will be
displayed on your
screen.
9. After approximately
60 seconds “Set
System Time” will be
displayed on your
screen. Use up and
down arrows to set
the time. Once time is
set press “DONE”
10. “Set System Date” will
be displayed on your
screen. Use up and
down arrows to set
the date. Once date is
set press “DONE”.
QUICK START GUIDE
Logic Combi C / Logic Max Combi C /
Vogue GEN2 Combi / Vogue Max Combi
In the unlikely event that commissioning is unsuccessful (e.g. central heating
will not switch on or will not switch o), electrically isolate the boiler,
remove 1 battery and repeat from step 6.



Blanking
Plate
Transceiver
Slot
INSTALLATION
For User & Installation Guide please visit www.idealboilers.com
1. Isolate electrical power to the
boiler.
2. Remove the blanking plate by
inserting flat blade screwdriver
into slot situated centrally at
bottom of blanking plate.
3. Remove link wire plug & keep in
a safe place.
4. Connect the transceiver
electrical plug.
5. Locate and push the transceiver
assembly into the boiler.
6. Insert only 3 batteries into the
Thermostat.
7. Turn electrical power back on
to the boiler and immediately
insert the fourth battery into the
Thermostat.

1Press the Thermostat screen. If screen does not
illuminate then replace batteries.
Battery Replacement:
Un-clip the thermostat from its cradle by sliding the
thermostat upwards.
Using a flat bladed screwdriver pop o the rear cover
Replace batteries
Refit battery cover
Batteries should operate for approximately 18 to 24
months. Only good quality alkaline batteries are to be
used.
2If warning triangle is shown then press it.
If “Zone 1 Fault” shown refer to Location Guidelines (opposite).
If “Boiler Fault” shown, check boiler display and refer to boiler
installation manual.
3If Time / Day at top left of display is incorrect, change by pressing
“Menu” > “Help & Settings”.
4If Central Heating will not switch on check Target Room
Temperature is at least 1°C greater than Actual Room Temperature.
If not press radiator symbol at bottom left of screen until “On” is
highlighted then rotate outer ring clockwise.
If Central Heating will not switch o press radiator symbol until
“O” is highlighted.
5Check power to boiler is on (boiler display should be on).
6If boiler transceiver left hand RF light is o, refer to Location
Guidelines (opposite).
7For Logic Combi C Boilers - ensure boiler Mode Knob is in Winter
position.
For Vogue Gen2 Combi Boilers - ensure Central Heating knob is
fully clockwise.
8If the fault persists then isolate the boiler, remove 1 thermostat
battery and repeat Quick Start Guide instructions from Step 6 (see
front page).
9If the Touch Thermostat replaced an existing thermostat, ensure
that boiler installer connection link wire is in place (see boiler
manual).
TROUBLESHOOTING

LOCATION GUIDELINES
USING THE TOUCH THERMOSTAT
In between your boiler and the Touch Thermostat there must be:
• Less than 20 metres
• No more than 2 walls and 1 ceiling
• No large metallic objects (e.g. American fridge/freezer)
• No large mirrors or windows
• No walls running along the RF path
The Thermostat must not be within 1 metre of a WiFi booster / router
Rotate outer
ring to change
target
temperature
or to boost in
an o period
Press here
to change
Operating
Mode
Press “MENU”
to access time
programs and set
time / date
Actual room
temperature
display

All Ideal Touch Controls oer customers the comfort of a 12 month Ideal Guarantee, subject
to the following terms and conditions. During the period of the guarantee we will replace
free of charge, where it suers a mechanical or an electrical breakdown as a result of
defective workmanship or materials, subject to the following conditions and exclusions;
WARRANTY
1. The guarantee will commence from
the date of installation. Without
proof of purchase the guarantee
will commence from the date of
manufacture (via serial number).
2. The Installation needs to be registered
within 30 days of installation, it
can be registered online by visiting
www.idealboilers.com.
3. If the control suers a mechanical or
an electrical breakdown we should
be contacted on one of the following
numbers:
Northern Ireland: 02890 331444
Elsewhere in the UK: 01482 498660
Our normal working times, excluding
Bank Holidays, are:
8am – 6pm Monday to Friday
8am – 4pm Saturday
8am – 12 noon Sunday
4. The guarantee does not apply:
a. To any defect, damage or
breakdown caused by deliberate
action, accident, misuse or third party
interference including modification or
failed batteries.
b. To any defect, damage or
breakdown caused by the design,
installation and maintenance of the
central heating system.
d. To any other costs or expenses
caused by or arising as a result of the
breakdown of the controls.
e. To any defect resulting from the
incorrect installation of the controls.
To any costs incurred during delays in
fixing reported faults.
Our Ideal Guarantee is oered in addition
to the rights provided to a consumer by
law. Details of these rights can be obtained
from a Trading Standards Authority or a
Citizens Advice Bureau.
Guarantor – Ideal Boilers Ltd, P.O. Box 103,
National Avenue, Hull, HU5 4JN.
Consumer Helpline T: 01482 498660
Technical Helpline T: 01482 498663
217623 A03