IDEAL Vogue Combi c26 User manual

When replacing any part on this appliance, use only spare parts that you can be assured conform to the safety and
performance specification that we require.
Do not use reconditioned or copy parts that have not been clearly authorised by Ideal.
RF MECHANICAL PROGRAMMABLE
ROOM THERMOSTAT, 24 HOUR - USER GUIDE
Vogue Combi c26, c32, c40

2
RF Mechanical Programmable
Room Thermostat, 24 Hour
The national regulations and respective safety instructions are to be observed.
Interferences and changes to the device will lead to cancellation of the warranty.
SETTING UP
Slide clock cover off.
The outer dial should be set to the current time. Rotate
the dial slowly in a clockwise direction, until the correct
hour is aligned with the arrow printed on the dial.
Note that the outer dial is printed with the 24hr clock
8.00am = 8 on the dial,
8.00pm = 20 on the dial.
Clock hands will allow for ne adjustment of the current
time setting of the dial.
Do not attempt to rotate the dial in an anti-clockwise
direction.
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
22
23
24
12
6
3
esp9460a
A
lign current
time to arrow
Outer dial
24hr cloc
k
9
Note. To access user instructions on room
thermostat/programmer, slide cover marked “info”.
Suitable for the following boilers:
Vogue Combi

3
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
22
23
24
12
6
3
esp9460a
Align current
time to arrow
Outer dial
24hr clock
9
PROGRAMMING SWITCHING TIMES
Set tappets to outer edge for ON periods and set tappets to inner
edge for OFF periods.
The example shown has been set with 2 on periods.
ON at 9.00am. OFF at 1.00pm. (13 hours)
ON at 6.00pm. (18 hours) OFF at 10.00pm (22 hours)
MANUAL SWITCH OPERATION
To set the programmable room thermostat for timed operation moved the
switch labelled “OFF/ /ON” to the “ “ position.
To set the programmable room thermostat to be continuously on, move the
switch labelled “OFF/ /ON” to the “ON” position.
To set the programmable room thermostat to be continuously off, move the
switch labelled “OFF/ /ON” to the “OFF” position.
Switches between
OFF & ON. dependant on
position of tappets.
SETTING TEMPERATURES
Turn the temperature dial to the room
temperature you would like the central
heating to achieve during central heating
on periods.
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
22
23
24
12
6
3
esp9460a
Align current
time to arrow
Outer dial
24hr clock
9

The low battery warning LED on the front of the unit will ash yellow to
indicate battery replacement. The unit will continue normal operation until
the LED ashes red and the unit will stop operation.
To replace batteries remove the front of the programmable room thermostat
from the mounting panel to gain access.
The unit required 2 x AA 1.5V Batteries.
Batteries should operate for approximately 18 months.
Only good quality 1.5V alkaline batteries should be used. DO NOT use
re-chargeable batteries as they only have a terminal voltage of 1.2V
nom.
If the batteries are not replaced and no signal is received by the receiver,
the light on the front of the receiver on the boiler will ash rapidly.
After 1 hour the boiler will operate in “Emergency Mode” (heating on for 4
mins and off for 9 mins) until the batteries are replaced.
Once batteries have been replaced, ALWAYS operate the reset button.
BATTERY REPLACEMENT
3G9465a
Batteries 2 x AA
Reset Button
(under cover)
Low Battery Warning LED
Ideal Boilers Ltd., P.O. Box 103, National Ave, Kingston Upon Hull, HU5 4JN.
Tel. [phone] Fax. [phone]. Registration No. London 322 137.
Ideal Stelrad Group pursues a policy of continuing improvement in the design and performance
of its products. The right is therefore reserved to vary specication without notice.
August 2012 UIN 208946 A01