idesk 401 User manual

IMPORTANT ADDITIONAL
INSTALLATION INFORMATION (idesk Seating)
1/9
A red bag containing Extra Hardware is included where applicable
Model 401

IMPORTANT ADDITIONAL
INSTALLATION INFORMATION (idesk Seating)
2/9
Installation tip for installing adjustable arm. Bolted Cap (Item L) must be aligned with the Long Bolt (Item M).
(Armrests for future shipment will be fully assembled.)
Model 402
Cx1
Lx1
Mx1 Mx1
Bx1
Lx1
Bolted Cap L
Long Bolt M

IMPORTANT ADDITIONAL
INSTALLATION INFORMATION (idesk Seating)
3/9
To ensure the bolted cap does not rotate out of alignment, place a thin piece of tape over bolted cap prior to installation.
(Armrests for future shipment will be fully assembled.)
Model 402
Thin tape

4/9
Installation tip for installing slip cover.
Model 402
2) Remove old slip cover and foam
from seat pan by unfastening
the velcro fasteners on the back
and front of seat. Remove the
back fasteners first.
3) Unzip old slip cover and remove
from foam.
4) Install new slip cover onto
the foam.
5) Make sure all four slip cover
corners match to the foam
corners, top & bottom.
Close zipper approximately 2”.
5) Align 2 front corners and
install using velcro fasteners.
Li back of seat and zip
up slip cover. Align 2 back
corners and install using
velcro fasteners.
2) Assemble chair.
IMPORTANT ADDITIONAL
INSTALLATION INFORMATION (idesk Seating)

5/9
Carefully review the part labels and Steps 3A and 3B of the assembly instructions prior to installation.
Model 403
Back Leg Caster
Insert is angled
IMPORTANT ADDITIONAL
INSTALLATION INFORMATION (idesk Seating)

6/9
Installation tip for installing leg end caps.
Model 403
Hold leg rmly and install
with steel hammer
IMPORTANT ADDITIONAL
INSTALLATION INFORMATION (idesk Seating)

7/9
Verify that items E and F are tight as the back can be loose and wobble
Model 403
Ex1
Dx1
Ex1
Dx1
F
Cx1
F
Cx1
IMPORTANT ADDITIONAL
INSTALLATION INFORMATION (idesk Seating)

8/9
Verify that back leg is properly installed in leg bracket or legs may not be level causing it to rock.
Model 403
Back Leg Bracket
Back Leg Notch
IMPORTANT ADDITIONAL
INSTALLATION INFORMATION (idesk Seating)

9/9
Installation tip for installing legs and leveling the legs on a flat surface.
Model 403
Rotate leg until
tab in leg bracket
slips into notch in
back leg
Push down on all
four legs to level
Chair leg end caps
are not leveled
FLoosen item F
FRetighten
IMPORTANT ADDITIONAL
INSTALLATION INFORMATION (idesk Seating)