idesk Pommerac Chair User manual

Warning
1. Product is for single person use only.
2. Do not use this chair unless all bolts and knobs are securely tightened.
3. Check that all bolts and knobs are tightened every six months or as needed.
4. Dispose of packing material properly. Do not use plastic cover as a head covering.
Suocation may result.
5. Do not use this chair as a stepladder.
For assistance, call [phone], or www.youtube.com/user/ideskinc1
Assembly Instructions
POMMERAC
1Put chair frame on a hard level surface.
2
4
3
Assemble back shell onto chair
frame.
Align holes in back shell with threaded holes in chair
frame. If holes do not align, press back shell as
shown.
Install screws into chair frame and
tighten with hex wrench. 5
A
B
B
C
Hard level
surface.
Back Shell
BLK/WHT
G00086BLK / G00086WHT 1A
Item Part Name Part # Qty
Sled Frame Seat
BLK/WHT
G00087BLK / G00087WHT 1B
Bar Stool Frame Seat
BLK/WHT
G00089BLK / G00089WHT 1
B
4-Leg Frame Seat
BLK/WHT
G00090BLK / G00090WHT 1
B
Screws G00088 2C
Hex Wrench G00091 1D 2.5mm
A
R1

Chair 1A
Seat Pad
BLK/WHT
G00083BLK / G00083WHT 1B
Seat Pan Cover G00084 1C
Item Part Name Part # Qty
Warning
1. Product is for single person use only.
2. Do not use this chair unless all bolts and knobs are securely tightened.
3. Check that all bolts and knobs are tightened every six months or as needed.
4. Dispose of packing material properly. Do not use plastic cover as a head covering.
Suocation may result.
5. Do not use this chair as a stepladder.
For assistance, call [phone], or www.youtube.com/user/ideskinc1
Assembly Instructions
POMMERAC CUSHION
1
2
Please prepare a pencil
and rubbing alcohol
Put the seat pad on the
center of the seat pan 1”
from front. Mark with a
pencil along the seat pad
edge on the PP seat
35 4
Peel o film of each adhesive
foam tape under seat pad.
Peel o the film of adhesive
foam tape under seat pan
cover.
Press seat pad firmly onto the seat
pan.
7
Place chair on a flat table as shown.
Confirm the seat pan cover arrow
sign is facing the front of the chair.
Put one side of seat pan cover into
frame as shown below.
Press seat pan cover gently and
make sure seat pan cover and
velcro adhere. Turn the chair
to normal use position. The
assembly is completed.
6Repeat procedure for other side.
Make sure all the tabs of all four
corners are tucked under the
chair frame.
8
A
C
A
C
B
A
Press
C
A
A
B
B
Center
1”
A
Peel o!
Velcro Tabs
B
A
Peel o!
Velcro Tabs