idesk MUSE User manual

Seat Shell
RED/WHT
G00074RED/G00074WHT 1A
Frame
G00075 1B
Bottom G00077RED/G00077WHT 1D
Washers G00079 1F
Hex Wrench G00081 1
H
Chair Legs
RED/WHT/WOOD
G00076RED/G00076WHT/G00076WOOD 1
C
Nut Plate G00080 1G
Screws G00078 1
E
Item Part Name Part # Qty
Warning
1. Product is for single person use only.
2. Do not use this chair unless all bolts and knobs are securely tightened.
3. Check that all bolts and knobs are tightened every six months
or as needed.
4. Dispose of packing material properly. Do not use plastic cover as a head
covering. Suocation may result.
5. Do not use this chair as a stepladder.
For assistance, call [phone], or www.youtube.com/user/ideskInc1
A
B
C
Assembly Instructions
MUSE CHAIR
13
5
2
Turn seat shell upside down.
Push nut plates into slots on the
bottom of seat shell with a flat
screwdriver. All nut plates are
identical.
Install washers and screws through
frame and bottom as shown into nut
plates and tighten with hex wrench.
Place frame above bottom.
Make sure the holes in frame
and bottom are aligned with
the threaded holes in the nut
plates.
Turn the chair to normal use
position and make sure all 4 legs
touch the ground. In case of
uneven floor, rotate the chair legs
to level the chair.
4Fasten chair legs onto frame as
shown.
With the arrows on bottom facing the
front of the chair, place bottom on seat
shell. Make sure the holes in the bottom
are aligned with threaded holes in the
nut plates.
6
5mm
slot
G
G
D
A
B
D
A
C
B
C
B
D
F
E

Muse Chair
1A
Cushion G00272GRY
1B
Item Part Name Part # Qty
Warning
1. Product is for single person use only.
2. Do not use this chair unless all bolts and knobs are securely tightened.
3. Check that all bolts and knobs are tightened every six months or as needed.
4. Dispose of packing material properly. Do not use plastic cover as a head covering.
Suocation may result.
5. Do not use this chair as a stepladder.
For assistance, call [phone], or www.youtube.com/user/ideskinc1
1Clear the surface with cleaning solution.
Place the cushion (B) on the center of the
seat shell (A) and make sure the position
does not exceed the seat edge.
2
Peel o the film of each adhesive foam
tape under cushion (B). Make sure to align
cushion (B) then press it firmly onto the
seat surface.
Assembly Instructions
MUSE CUSHION
A
Peel off !
Press!
B
A
B
Align cushion with
PP curvature