idesk 403B User manual

For assistance, call [phone], or www.youtube.com/user/ideskinc1
r
3A 3B
1
Ax1
Dx1
Ex1
Bx1
Dx1
Ex1
Warning
1.
2. Do not use this chair unless all bolts and knobs are securely tightened.
3. Check that all bolts and knobs are tightened every six months or as needed.
4.
5. Do not use this chair as a stepladder.
Item Part Name Part # Qty
ABack Frame G00042/G00053
1
BG00043/G00054 1
C
D G00045 2
E Long Bolt G00046 2
F
4mm Hex Wrench G000 66 1
G
6mm Hex Wrench G00048 1
H
Leg End Cap
G00049 4
J
K
L
2/1egap,stnetnoCegakcaP
Assembly Instructions Side Chair
403B/403W OROBLANCO
1.
. d e n e t h g i
s h t n o m x i s y
or as needed.
4.
5. Do not use this chair as a stepladder.
For assistance, call [phone] or www.youtube.com/user/ideskInc.
A
B
C
Arm Frame
Back Leg G00044 2
Flat Washer
Front Leg Caster Insert (2)
(Optional)
Back Leg Caster Insert (2)
(Optional)
Casters (4)
(Optional)
403CASTERS 1
(straight)
(angled)
Short Bolt G00073
M
2
A
B
Removable
warning label
Removable
warning label
C
2
Cx1
Cx1
F
F
Push in and rotate leg until
tab engages in slot in leg
WARNING
HEX SCREWS
(2) MUST BE
TIGHTENED
BY HAND
PRIOR TO
USE
3/2016
OVER-TIGHTENING THE SCREW
WILL DAMAGE THE PARTS
Steel hammer
required
(install with side
of hammer)
Steel hammer
required
(install with side
of hammer)
Assembly Instructions Side Chair
403B/403W OROBLANCO
Shipping carton
Shipping carton
Assembly Instructions Side Chair
403B/403W OROBLANCO

2) Remove law label and weight
capacity label and put to the side.
Unzip and the old slip cover and
remove
3) Install new slip cover. Make
sure all 4 slip cover corners
and bottom holes on bottom
on the seat pan
4) Re-attach the seat pan to the slip
step 1. Re-apply the law label and
weight capacity label. Make sure
labels are pressed down hard to
ensure attachment
Assembly Instructions Slip Cover
403B/403W OROBLANCO
403B/403W OROBLANCO
Assembly Instructions Slip Cover