3
7�3�1 Shorten the probe�������������������������������������������������������������������������������19
7�3�2 Determine probe length ����������������������������������������������������������������������20
7�4 Installation of the unit in the tank �����������������������������������������������������������������20
7�4�1 Installation in open tanks (e�g� for secondary processes) ������������������22
7�4�2 Installation in plastic tanks (e�g� for secondary processes) ����������������22
7�4�3 Notes on the use in accordance with EHEDG������������������������������������23
7�4�4 Notes on the use according to 3-A �����������������������������������������������������24
8 Electrical connection������������������������������������������������������������������������������������������25
9 Operating and display elements ������������������������������������������������������������������������26
10 Menu����������������������������������������������������������������������������������������������������������������27
10�1 Menu structure�������������������������������������������������������������������������������������������27
10�2 Explanation of the menu����������������������������������������������������������������������������29
10�2�1 Main menu����������������������������������������������������������������������������������������29
10�2�2 Level EF (extended functions)����������������������������������������������������������29
10�2�3 Level CFG (configuration) ����������������������������������������������������������������30
10�2�4 Level ENV (environment) �����������������������������������������������������������������30
10�2�5 SIM level (simulation) �����������������������������������������������������������������������30
11 Parameter setting���������������������������������������������������������������������������������������������31
11�1 Parameter setting in general����������������������������������������������������������������������31
11�2 Basic settings (set-up) �������������������������������������������������������������������������������33
11�2�1 Enter probe length ����������������������������������������������������������������������������33
11�2�2 Carry out tank adjustment�����������������������������������������������������������������33
11�3 Configure display (optional) �����������������������������������������������������������������������34
11�4 Setting of output signals�����������������������������������������������������������������������������34
11�4�1 Setting of the output function for OUT1 ��������������������������������������������34
11�4�2 Set the switching limits (hysteresis function) ������������������������������������34
11�4�3 Set the switching limits (window function) ����������������������������������������35
11�4�4 Set switch-on delay for switching outputs�����������������������������������������35
11�4�5 Set the switch-off delay for switching outputs�����������������������������������35
11�4�6 Setting of the output function for OUT2 ��������������������������������������������35
11�4�7 Scale analogue signal�����������������������������������������������������������������������36
11�4�8 Set output logic for the switching outputs �����������������������������������������36
11�4�9 Response of the outputs in case of a fault����������������������������������������36
11�4�10 Set damping for the measured signal ���������������������������������������������36
11�4�11 Set delay time in case of a fault ������������������������������������������������������36
11�5 Reset all parameters to factory setting ������������������������������������������������������36