IKEA IDÅSEN User manual

IDÅSEN
Design Jon Karlsson

ENGLISH
FRANÇAIS
ESPAÑOL
4
10
18

IMPORTANT
SAFETY
INSTRUCTIONS
When using an electrical furnishing, basic
precautions should always be followed,
including the following:
Read all instructions before using the
product.
DANGER
To reduce the risk of electric shock:
Always unplug this furnishing from the
electrical outlet before cleaning.
WARNING
To reduce the risk of burns, re, electric
shock, or injury to persons:
1. Unplug from outlet before putting on or
taking off parts.
2. Close supervision is necessary when this
furnishing is used by, or near children,
invalids, or disabled persons.
3. Use this furnishing only for its
intended use as described in these
instructions. Do not use attachments not
recommended by the manufacturer.
4. Never operate this furnishing if it has a
damaged cord or plug, if it is not working
properly, if it has been dropped or
damaged, or dropped into water. Return
the furnishing to a service center for
examination and repair.
5. Keep the cord away from heated
surfaces.
6. Do not use outdoors.
7. Do not operate where aerosol (spray)
products are being used or where oxygen
is being administered.
8. The table must not be overloaded –
maximum load is 75kg/165lbs
9. Only use intended IKEA table tops.
Advice and instructions for IDÅSEN.
Sound level:
Lower than 55 dB(A).
Height setting interval:
60-124 cm/23.6-48.8 inch
Maximum load:
75kg/165lbs.
Temperature interval at usage:
+10 °C up to + 40 °C/+50 up to +104 °F.
Temperature interval at storage:
-18°C up to 70°C/0 up to 158°F.
Humidity:
20% up to 90% at 40°C/104°F.
Power supply unit:
DC 24V, 140W.
Model:
ASW0551-24020002A
This appliance shall only be used
together with the included power
supply unit.
Every person who is responsible for this
table at installation or employment of
the table in daily use or in service and
repair work should carefully read these
instructions. Keep these instructions close
to your sit/stand table.
ENGLISH 4

Installation instructions
— The table is assembled according to
separate assembly instructions.
— Connect the cable from one leg to the
other. Connect the hand control and
the power supply to the leg. The cables
to legs, hand control and power supply
should be placed in the tray created by
the frame. Place the electrical cables
so that they do not get damaged, see
assembly instruction.
— Connect the electrical cable to a wall
socket.
NOTE! The electrical cable must have
full mobility.
— The table is now ready for use. The
motors stop automatically when the
table reaches its lowest and highest
position respectively.
Usage of the table
— The table shall only be used as a
working table with the possibility to
continuously adjust working height
between sitting and standing position.
The table shall only be used indoors and
in dry premises (ofce environment or
similar).
The table must not be overloaded -
maximum load is 75 kg/165 lbs. The
system may be run continuously for
maximum 2 minutes. Afterward, the
motors must stand by for approx. 18
minutes before they can be used again.
QUICK GUIDE
If you have an IOS device:
Go to the App Store and download the Desk
Control app. The app will take you through
the process of installing your Desk control.
If you have an Android device:
Go to Google Play and download the Desk
Control app. The app will take you through
the process of installing your Desk control.
Add additional Bluetooth device(s)
(max 8 devices)
1. Go to your Bluetooth menu on your
mobile device and connect to DESK-
xxxxx.
2. Once Bluetooth connection is
established, the blue LED stops blinking.
Up to 8 devices can be stored by the
system. When the 9th device is paired the
system will remove the device that have
not been connected for longest time
Factory reset:
Press manoeuvre button for 10 sec. This
deletes all paired Bluetooth devices.
5

Follow these instructions when
adjusting table height:
1. Make sure no objects are in the way of
the table adjusting height freely.
2. In order to run the table up/down, press
the manoeuvre button up and down
respectively or use your Desk control
app.
Safety regulations
— When the table is run up/down, keep
the necessary safety distance to avoid
the risk to get squeezed between the
moving table top and xed objects in
the surrounding area.
— When the table is run up/down the
user shall keep watch so that nobody
is injured or no object is damaged. The
table top must not bump into a xed
object so that the table is overturned.
Always remove any ofce chair before
the table is run up/down.
— The table tripod must not be altered or
reconstructed in any way. In service and
repair work of the table, the electrical
cable must always be disconnected from
the wall socket.
— Modications to the legs are absolutely
forbidden!
— The table must not be used as a hoisting
device for persons.
Maintenance and repair instructions
— After approx. 1 week of use, check that
the screws are properly tightened.
— If the table cannot be lowered or raised,
check the connections between the legs
and the wall socket and be sure your
phone/Bluethoth device is turned on
and connected through the Desk Control
app.
— If any part of the electrical system is
replaced, the electrical cable must rst
be disconnected from the wall socket.
Replace the electrical part and then
connect the electrical cable to the wall
socket. The table is now ready for use.
If the table still does not work, please
contact your nearest IKEA store or
customer service.
PRODUCT SERVICING
Do not attempt to repair this product
yourself, as opening or removing covers
may expose you to dangerous voltage
points or other risks.
Manufacturer:
IKEA of Sweden AB
Address:
Box 702, SE-343 81 ÄLMHULT
SAVE THESE
INSTRUCTIONS
6

This device complies with Part 15 of the
FCC Rules/Industry Canada licence-exempt
RSS standard(s). Operation is subject to
the following two conditions:
(1) this device may not cause harmful
interference, and
(2) this device must accept any interference
received, including interference that
may cause undesired operation of the
device.
WARNING:
Any changes or modications to this unit
not expressly approved by the party
responsible for compliance could void the
user’s authority to operate the equipment.
NOTE:
This equipment has been tested and found
to comply with the limits for a Class B
digital device, pursuant to part 15 of the
FCC Rules. These limits are designed to
provide reasonable protection against
harmful interference in a residential
installation.
This equipment generates, uses and
can radiate radio frequency energy and,
if not installed and used in accordance
with the instructions, may cause harmful
interference to radio communications.
However, there is no guarantee that
interference will not occur in a particular
installation. If this equipment does cause
harmful interference to radio or television
reception, which can be determined by
turning the quipment off and on, the
user is encouraged to try to correct the
interference by one or more of the following
measures:
— Reorient or relocate the receiving
antenna.
— Increase the separation between the
equipment and receiver.
— Connect the equipment into an outlet on
a circuit different from that to which the
receiver is connected.
— Consult the dealer or an experienced
radio/TV technician for help.
The Bluetooth® word mark and logos are
registered trademarks owned by Bluetooth
SIG, Inc. and any use of such marks by
IKEA is under license. Other trademarks
and trade names are those of their
respective owners.
The crossed-out wheeled bin symbol
indicates that the item should be disposed
of separately from household waste. The
item should be handed in for recycling
in accordance with local environmental
regulations for waste disposal. By
separating a marked item from household
waste, you will help reduce the volume of
waste sent to incinerators or land-ll and
minimize any potential negative impact on
human health and the environment. For
more information, please contact your IKEA
store.
7

Trouble shooting guide
NOTE!
Do always disconnect the cable from the wall socket before maintenance!
8
Symptom Check Try
The desk does not run
Is the main connected to
the leg? Try to connect a lamp or similar to the main supply
to check that the supply
voltage is OK.
Are all plugs mounted
correctly between the legs
and power supply? See
assembly instruction.
Check all connections.
Are there visual damages
on the cables, controls or
the legs?
Damaged parts must be
exchanged - Contact IKEA
Customer Service.
The desk stops and can
only run in the opposite
direction.
Is the desk in fully
extracted position? When the desk has reached its upper position it can only
run downwards.
Is there much load on the
desk compared to when the
desk functioned normally?
Remove some of the load
and try again.
The desk will only run
downwards even though the
desk is not overloaded.
Perform Basic settings.
The desk does not run with
full stroke length upwards.
Always stops at the same
position.
The system has a new
endstop outwards. Perform
Basic settings to remove
this stop.
The desk does only run a
little upwards and stops.
Has the correct screws been
used when mounting the
frame to the legs?
Check if the screw used
have the correct length
(assembly instruction). If
the screw is too long it can
damage the leg.
Is all connections correct? Check all connections.
Is the desk loaded much? Reduce weight load and try
again. A Basic setting might
be needed before the desk
will drive upwards.
Basic Setting:
Push the controller downwards. Run the table to the bottom position and keep the
pressure on the controller for min. 6 seconds after both legs have reached bottom
position.
At certain errors types this must be done twice in succession. Now the desk is in initial
position.

Technical data
9
Model Name IDÅSEN Motorised desk/table
Type number D1801
Input 120V~60Hz 1.2A
Standby Power Consumption <0.1 W
Operating temperatures 10°C to 40°C/+50 to +104 °F
Operating humidity 20 to 90%RH at 40°C/+104 °F
Sound level: <55 dB(A)
Height setting interval: 60-124 cm/23.6-48.8 inch
Maximum load: 75kg/165lbs
Bluetooth Version V 4.2
Wireless range in open air 8-10 m/26’ - 32’
Operating frequency 2.4 - 2.48 GHz
Radio output power +4dBm

CONSIGNES
DE SECURITÉ
IMPORTANTES
Lors de l’utilisation de mobilier équipé
d’un dispositif électrique, des précautions
élémentaires doivent être observées, dont
les suivantes :
Lires toutes les instructions avant d’utiliser
ce produit.
DANGER
Pour réduire le risque de choc électrique :
Toujours débrancher le dispositif électrique
de l’alimentation générale avant de
nettoyer le meuble.
ATTENTION
Pour réduire les risques de brûlure,
d’incendie, de choc électrique ou de
blessure :
1. Débrancher le dispositif électrique de
l’alimentation générale avant de xer ou
retirer des pièces.
2. Une surveillance étroite est nécessaire si
le meuble est utilisé par un enfant, une
personne inrme ou handicapée, ou à
proximité de ces personnes.
3. Utiliser ce meuble uniquement pour
la fonction qui est la sienne en se
conformant aux instructions. Ne pas
utiliser de pièces non recommandées par
le fabricant.
4. Ne jamais utiliser ce meuble si un
câble ou une prise de courant sont
endommagés, s’il ne fonctionne pas
correctement, s’il a subi un choc ou est
endommagé, ou s’il a été en contact
avec de l’eau. Rapporter le meuble à un
atelier pour examen et réparation.
5. Maintenir le câble à distance de toute
source de chaleur.
6. Ne pas utiliser à l’extérieur.
7. Ne pas faire fonctionner le dispositif
électrique en cas de diffusion de produits
sous forme d’aérosol (vaporisateur) ou
en cas d’administration d’oxygène.
8. Le plateau de table ne doit pas
être surchargé – charge maximum
75kg/165lbs
9. Utiliser uniquement les plateaux de table
IKEA prévus à cet effet.
Conseils et instructions pour
bureau IDÅSEN
Niveau sonore :
inférieur à 55 dB(A)
Intervalle de réglage de la hauteur :
60-124 cm/23.6-48.8 inch
Charge maxi :
75kg/165lbs.
Intervalle de température
pendant l’utilisation :
+10°C à +40°C/+50 à +104 °F.
Intervalle de température
pendant le stockage :
-18°C à +70°C/0 à 158°F.
Humidité :
de 20 % à 90 % à la température de
40°C/104°F.
Unité d’alimentation électrique:
CC 24V, 140W.
Modèle :
ASW0551-24020002A
Ce produit ne doit être utilisé qu’avec
l’unité d’alimentation fournie.
Toute personne qui installe, utilise
régulièrement ce bureau ou est
responsable de son entretien ou de sa
réparation doit lire attentivement ces
instructions. Conserver ces instructions à
proximité du bureau.
FRANÇAIS 10