IKEA METOD User manual

Assembly instructions METOD njufront.pl
1
Assembly instructions for side panels njufront.pl to
the IKEA METOD system
Content
IKEA ADDITIONALLY
NJUFRONT
Order of assembly
METOD body
Side panels
2
1x
1
1x
8x
1x
2x
Screws
Please follow the safety instructions attached to the furniture. It is
recommended to install the METOD bodies to the wall using the anchor
brackets supplied with the IKEA cabinet, especially in the case of high-
quality fronts.
Material that secures the floor

Assembly instructions METOD njufront.pl
2
Side panel assembly
Before mounting, make sure that the
surfaces of the elements are clean and
free from contamination.
Position the body of the furniture so that
the rear wall is on the ground. Using one
of the elements, for example a shelf
positioned along the upper part of the
cabinet, determine the parallel position of
the panel in relation to the upper part of
the cabinet.
Place the assembled element in a suitable
place so that its edges adhere to the
furniture body.
METOD
body
Shelf

Assembly instructions METOD njufront.pl
3
Side panel assembly
Rear view after assembly
Secure the panel with screws by placing
them on the inside of the body.
For fixing screws for side panels, you can
use the holes under the shelves.
When screwing the screws, press the
panel to the body with your hand. If you
have one, you can use a carpentry clamp
for this purpose.
Place the screws as evenly as possible.

Assembly instructions METOD njufront.pl
4
During assembly
Cleaning
Before assembly, the surfaces of the elements should be cleaned with a soft,
damp microfiber or cotton cloth.
Surfaces should be regularly cleaned with a soft, damp microfiber or cotton
cloth, using a mild cleaning solution for painted surfaces. After cleaning, wipe
the front with a damp cloth and wipe dry.
Avoid using undiluted or concentrated detergents with a strong effect; acetone,
ammonia, alcohol and other abrasives cleaning agents.
Avoid using bristles with hard bristles; abrasives in the form of pastes and
powders; sponge for scrubbing and sharp cloths.
When assembling panels and fronts, avoid shocks with hard or sharp objects
that may permanently damage the surface of the varnish.
Avoid exposing the surface of painted parts to contact with sharp objects.
Avoid bumping the elements against the ground. When laying down the
elements, soft-material should be used to protect them against damage.
Do you have questions or concerns about assembly? Contact us by phone 606
402 112 or by e-mail [e-mail]. We will try to help.