2
1. If the Battery Pack is connected to a trobe Head, turn the strobe OFF.
Place the strobe face down on a flat surface. The Battery Pack (rear
section of the strobe) does NOT remain waterproof when removed
from the strobe. Therefore, we suggest keeping the open portion of
your Battery Pack pointed down when removing from a strobe, to
eliminate the possibility of water droplets falling inside.
2. lide the locking lever out by either grasping the bottom sides of the
lever and pulling it out OR use your thumb to apply slight pressure to the
top of the lever and slide it out, Diagra 1.
3. Flip the lever up and then rotate the lever counterclockwise 90°. The
internal spring automatically pushes open the strobe. Lift the Battery
Pack off of the strobe front. The rear section of the strobe is the
Battery Pack.
4. Remove any water droplets from the Battery Pack using a soft cloth.
5. With the toggle in the open po ition, line up the Charging ocket Index
Tab with the Charging ocket,
Diagra 2, page 3.
6. Press the Battery Cover onto
the open end of the Battery
Pack, Diagra 3, page 3.
7. Hold the Battery Cover flush
on the Battery Pack with one
hand while rotating the toggle
clockwise 90° with your other
hand, Diagra 4, page 4.
8. Flip the Toggle down and push
in to lock.
Battery Cover Attach ent and Re oval
OPEN
MADE IN U.S.A.
UNLOCK
MADE IN U.S.A.
UNLOCK
Diagra 1
Grasp Lever
Flip Up Rotate
Pull Out
