iLive IAEB34 v938-03 User manual

Bluetooth Wireless Earbuds
User’s Guide for Model No. IAEB34 v938-03

ADDITIONAL WARNINGS
• To prevent re or shock hazards, do not expose this unit to rain or moisture.
• To avoid hearing damage, make sure that the volume on your music player is turned down
before connecting your headphones. After placing headphones in/on your ears, gradually
turn up the volume until you reach a comfortable listening level.
• Lithium batteries, like all rechargeable batteries, are recyclable and should be recycled
or disposed of according to state and local guidelines. They should never be disposed of
in normal household waste, and they should never be incinerated, as they might explode.
Contact your local government for disposal or recycling practices in your area.
• WARNING: This product may contain chemicals known to the State of California to
cause birth defects, or other reproductive harm (California Prop 65). Wash hands after
handling.
• This product meets and complies with all Federal regulations.

FCC WARNINGS
• Warning: Changes or modications to this unit not expressly approved by the party
responsible for compliance could void the user’s authority to operate the equipment.
NOTE: This equipment has been tested and found to comply with the limits for a Class B
digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a residential installation. This
equipment generates, uses, and can radiate radio frequency energy and, if not installed
and used in accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful interference to radio or television
reception, which can be determined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver
is connected.
• Consult the dealer or an experienced radio/TV technician for help.

FEATURES
• Supports Bluetooth
• Supports Advanced Audio
Distribution Prole (A2DP)
• Digital volume control
• Built-in microphone
• Driver: 10mm
• USB port for battery recharge
• Wireless range: 33 feet
• DC battery power: built-in
rechargeable lithium ion battery
• Battery life: approx. 6 hours audio
• 3 sets of eartips:
1 small, 1 medium, 1 large
• 2 detachable earhooks
• USB cable
• Carry pouch
INCLUDES

INTRODUCTION
Volume Up
Power/Play/Pause/
Speakerphone/
Pair
Press and hold to turn the
unit on and o.
Press to play or pause the
current track. Press to
answer an incoming call.
Volume Down
Pairing/Power
Indicator
DC InMic Installing and Wearing Earhooks
When connecting the earhooks you should hear a
snap or a click when put in to place.

BATTERY POWER
1. Connect the included USB cable to the USB port on a powered computer to
charge. Charge fully before use.
The indicator will display a red light when charging, and turn blue when fully
charged. Initial charge time is approximately 2 hours.

1. Power on the unit by pressing and holding the Power/Pair button for ~4
seconds. The indicator will ash red and blue.
When pairing, remain within 3 feet of the unit.
2. Using the native controls on your Bluetooth device, select IAEB34 in your
Bluetooth settings to pair. If your device requests a password, enter the default
password 0 0 0 0 .
3. Refer to the user’s manual for your specic device for instructions on pairing
and connecting Bluetooth devices. After initial pairing, the unit will stay paired
unless unpaired manually by the user or erased due to a reset of the device. If
your device should become unpaired or you nd it is unable to connect, repeat
the above steps.
PAIRING A BLUETOOTH DEVICE

PLAYING AUDIO WIRELESSLY
1. Follow the instructions for Pairing a Bluetooth Device.
2. Use the native controls on the connected Bluetooth Device to select a track.
3. To play or pause the selected track, use the native controls on the connected
Bluetooth Device or press the Power/Play/Pause/Speakerphone/Pair button.
4. Audio played through the connected Bluetooth device will now be heard
through the speakers.

USING THE SPEAKERPHONE
1. Follow the instructions for Pairing a Bluetooth Device.
2. When a call is received, a ringtone will sound through the earbuds speakers.
3. Press the Power/Play/Pause/Speakerphone button to accept the call or accept
the call with the native controls on the connected device.
4. The incoming call received through the device will now be heard through the
earbuds speakers.
5. To end the call, press the Power/Play/Pause/Speakerphone button or end the
call using the native controls on the connected device.
6. To re-dial the last dialed number,press the Power/Pair button twice.

LED INDICATORS
Status Indicators
Power on Flashing blue light
Power o No light
Charging Red light
Finished charging Blue light
Pairing mode Flashing red and blue lights
Low power Flashing red light