IMG Relaxer Chair User manual

PS! Please be aware that irregular use might cause risk and queeze
danger!
019 EN RELAXER 2012.11
MAINTANANCE SAFETY RULES
The back cover skirt must always be properly fastened with Velcro tape
to avoid somebody’s hands/fingers getting into the chairs mechanism
from the chair‘s backside.
Do not allow children to sit and play on or near the chair or to operate
the mechanism. The footrest might fold out and the child could get
injured.
Keep hands and feet away from the mechanism. Only the chairs user
should operate the mechanism.
Always leave the chair in upright position with folded in footrest.
Do not sit on the armrest.
Never sit on the footrest. Do not use the chair or footrest as step
ladder.
Never lift/carry the chair by the back or the footrest. Lift the chair by
grabbing under the chairs arms, base or backside.
The chair can only be used by one person at a time.
Armrest protection cover is recommended to use (for fabric cover).
If parts are missing, broken, damaged or worn – stop use of the
product until repairs are made, using factory authorized parts only.
Failure to follow these warnings could result in serious injury.
•
•
•
•
•
•
•
•
•
•
Our Relaxers/recliners have a mechanism with many joints, springs
and moving parts. As a result, it is natural that sounds/squeaks from the
chassis occur. There is no fault with the chair of that reason. If creaking/-
clicking noise occurs from the fitting you must tighten the screws
(Picture. 1 and 2) and smear all the joints with a drop of oil. Use
penetrating oil that not flows, such as penetrating oil spray. To prevent
sounds from the ball bearing spray the bullets inside the bearing with:
CRC white lithium grease, or similar.
Bolts, screws and knobs can loosen after an extended period. This can
create damage to the frame and instability to the furniture. Therefore, it
is important to check and tighten all bolts, screws and knobs periodically.
IMG recommends you to do this at least every four (4) months or as
needed.
PICTURE 2
PICTURE 1
Grease
CONGRATULATIONS
You are now the proud owner of Relaxer by IMG.
We are confident you will feel the same as you
enjoy the comfort and style of your new furniture.
IMPORTANT
Read this and other relevant instructions
before using the product. Keep this manual
for future reference.
ASSEMBLY INSTRUCTIONS
imgcomfort.com
IMG Group AS Postboks 251 N-6239 Sykkylven Norway
Tel: + 47 70 27 10 40 offi[email protected]

By using the handle located at the inside or outside of the right arm the
footrest can be unfolded and the back can be regulated into rest positions.
The glide/rocker function is locked as long as the footrest is unfolded.
The built-in footrest can be unfolded by pushing the handle placed inside
of the right arm - towards the back. To fold inn the footrest you should use
your feet to press the footrest down towards the chair and move your
bodyweight forward in the chair. Note: The handle must be in front position
to fold in the footrest. If the chair is equipped with an outside handle please
move the handle backward to unfold the built in footrest. To fold in the
footrest you should use your feet to press the footrest down in combination
with moving the handle forward.
Do not use shoes directly against the footrest. This might cause damage to
the cover/upholstery. Do not sit on the armrests. Never lift/carry the chair
by the back or the footrest. Lift the chair by grabbing under the chairs arms,
base or backside. Two persons are recommended to lift/carry the chair.
A
B
“CLICK”
STEP 1
Take the center arm and attach the 4 flanges (2 on each side) as shown in
the line drawing. It is two type of flange and the one in the front will be
marked FRONT on the flange.
STEP 2
Remove the connection protectors on the back and the flanges/brackets
protectors on the seat.
IMG Relaxers are delivered with separated back and seat. The back
is ready for assembly. Please proceed with the following steps:
STEP 3
Attach the back by sliding the connectors into the flanges/brackets on the
back part of the seat. Press the back down until you hear “click”. Please
ensure that you don’t tear the skirt cover or that the skirt cover gets
squeezed between the back and the seat.
STEP 4
Use the Velcro tape to fasten the skirt cover onto the lower part of the chair
(the cover goes from the back to the back rail frame).
RELAXER, ASSEMBLY INSTRUCTIONS RELAXER, USER INSTRUCTION
PLEASE READ THIS INFORMATION CAREFULLY BEFORE YOU
ASSEMBLE AND USE THE CHAIR.
UNFOLDED FOOTREST (OUT)
The back angel can be
adjusted from upright to rest
positions
The glide/rocker function is
locked when the footrest is
unfolded (out)
With 360 swing function
You can adjust the neck
and head support
•
•
•
•
FOLDED FOOTREST (IN)
The back is locked in
upright position.
The glide/rocker function
can be operated.
With 360 swing function.
You can adjust the neck
and head support.
•
•
•
•