impekk The Essential-LTM-2L-GA/EL-1 User manual

ELECTRIC TABLE
Model: The Essential - LTM-2L-GA/EL-1
Assembly and instructions

1
Use - Liability
This height adjustable desk has electric motors and is designed for use in dry work areas only. The desk height is
adjustable so that it can be positioned at the most ergonomically suitable height. Any other use is at user’s risk.
Under no circumstances does the manufacturer accept warranty or liability claims for damages caused from
improper use or handling of the desk frame.
Make sure there are no obstacles in the desk’s path.
Make sure the desktop is not touching any walls.
Make sure all cords are of appropriate length to accommodate the change in height.
Children should only operate desk under adult supervision.
There is a risk of injury and electric shock if not properly installed.
Keep liquids away from electrical components.
Do not sit or stand on the desk frame.
Do not crawl or lie under the desk frame.
Do not place any object taller than 508 mm (20”) underneath the desk .
Do not open any of the electrical components. There is a danger of electric shock.
This product is designed with a duty cycle of 10% (2min. on, 18 min. o).
In the event of a power outage or if the power cord is unplugged, a manual reset may be necessary.
Weight capacity: 172 kg ( 380 lb )
1-
2-
3-
4-
5-
6-
7-
8-
9-
10-
11-
12-
13-
Caution!
In the event of a power outage or if the power cord is unplugged, a manual reset may
be necessary. Press the two arrows at the same time untill you hear the alarm ringing.
Then, lower the table to its lowest position. Your desk is now ready to use.

2
Power Cord
Control switch
8x
10x
Control Box
Electrical Motor
8x
5mm
1x
1x
2.5mm
12x
Parts Included
Frame
Hardware
Electrical components
4x
2x
6x
Please note that B & H are preassembled. h
h

3
Assembly instructions
Complete this step for both legs.
The tabs must be on the oor.
5mm
Step 1
Step 2 4x
4x
Part B and H are preassembled. You must adjust them to approximately
match the length of your table. Do not tighten the screws completely
before the nal adjustments. h
b

4
2.5mm
Insert the shaft into the gearboxes mounted on the legs. Do not tighten the screws
completely before the nal adjustments.
2.5mm
5mm
Step 3
4x
2x

5
Complete this step for both legs.
Map out the desired position of the legs. For maximum stability, center the legs on the table.
Adjustable width of 1100 mm to 1600 mm ( 43 5/16” - 63”). We suggest to use a tabletop with a minimum thickness of 25,4 mm (1”).
Step 4
Step 5
8x
8x
Do not overtighten fasteners.

6
Install the legs to the underside of the table top.
2.5mm
Adjust the length of the legs and the shaft before you attach the table top.
Make sure no screws protrude from the shaft as they would rub against the
leg brackets during operation.
Please center the tubing for best results.
Step 6 10x
Tighten

7
INSTESSE-R1
Connect the control switch to the control box. Connect the motor to the control box.
Connect the power cord to the control box.
Install the control switch so that it does not exceed the table top. Install
the control box where it won’t interfere with the lift mechanism. Follow
the steps below to connect the electric components. When all the
connections are done, ask a second person to help you lift up the table.
2 Height setting control buttons.
Control Box
Step 6
4x
A
B
C