Inateck BCST-70 Quick guide

https://wiki.teltonika-gps.com/view/Inateck_BCST-70_Configuration
Inateck BCST-70 Configuration
Main Page > Accessories > Inateck BCST-70 Barcode Scanner > Inateck BCST-70 Configuration
Contents
1 Configure FM device using Teltonika configurator
2 Enable Bluetooth Pairing
3 Scanner Auto Connect Configuration
Configure FM device using Teltonika configurator
In System settings, enable Codec8 Extended1.
In GPRS settings, configure GPRS Settings and Server Settings.2.
In Bluetooth settings,3.
Enable Bluetooth, set this setting as either "Enable (hidden)" or "Enable (visible)",
otherwise Bluetooth will be disabled
Under Bluetooth Control, click Discover so it would detect devices within vicinity.
Once devices are discovered, select BCST-70-XXXX-SPP then proceed to tick Pair
After successful pairing, scanner should show under Paired Devices.
NOTE: : If in case the Scanner is not discovered, do the following steps on Bluetooth Pairing.
Enable Bluetooth Pairing
Scan “Enter Setup”a.

Scan “ Bluetooth Pairing”b.
Scan the "Exit with Save" barcodec.
Scanner Auto Connect Configuration
Fill up the “Auto Connect To External Device“ with as follows:
Select Connection Mode as, Inateck Scanner.
Enter the External MAC, can be seen on Paired Devices at the upper left corner.
Enter the External Name, can be seen on Paired Devices at the lower right corner.
Enter the External Pin, if the scanner has pin code set otherwise leave as blank.
Fill up the “Authorized Devices MAC List“ same with the External MAC.
NOTE: : It is important to fill out the auto connect so you won‘t need to Pair the device again on the
Configurator.
To receive the data to server enable corresponding BT Status IO element to Low.
NOTE: : If Scanner is connected BT Status value would be read as 2