InCarTec 29-UC-REN1-NAV User manual

29-UC-REN1-NAV
RENAULT ISO Canbus
STEERING CONTROL INTERFACE
WITH NAVIGATION RETENTION
Laguna III 2007>
Clio III 2009>
This interface will automatically turn on the navigation unit when the engine is
running.
You can manually turn on the navigation unit by pressing and holding the mute
button on the steering wheel.
This interface needs to be set up for the make of head unit being fitted.
Use this interface along with a head unit specific patch lead, there is a 4pin black
connector at the end of 3 wires from the UNICAN interface, this is where you will need to
connect the head unit patch lead.
When connected, the CANbus interface will automatically recognise the vehicle. The
green LED on the interface will repeatedly flash once followed by a pause.
You will need to set the interface to the make of head unit you are fitting.
The amount of flashes between pauses corresponds to the make of head unit, see the
table overleaf for the number of flashes and which make it corresponds to.
While the LED is flashing green, press the Vol +/- buttons on the cars steering wheel to
change the amount of flashes between pauses, Vol + will increase the amount of flashes,
Vol– will decrease the amount of flashes.
When you have the correct amount of flashes, press seek+ to confirm and the LED will go
to a solid green light.
Mini ISO
UNICAN PLUS
105.1 mHz
Connect the YELLOW
WHITE wire to the MUTE
input of the aftermarket
radio
NAVIMUSIC
Connect the wire YELLOW
WHITE of navimusic with the
YELLOW WHITE
of the P&P cable
Connect the 29-UC-REN1-NAV to the
vehicle as detailed in the diagram.

Number of
flashes
Make of head unit
1Clarion (Default)
2Kenwood
3JVC
4Alpine
6Pioneer (Set jumper)
7Sony
To reprogram the interface for another head unit Brand
Keep the ignition on
1. Disconnect the interface from the 14 Pin connector.
2. Push the red button in and keep it pushed in.
3. Reconnect the interface to the 14 Pin connector
4. The LED will flash green then go off.
5. Release the red button .
6. The LED will flash red then green.
7. Use Vol+/- on the car to set the amount of flashes
8. Confirm selection with Seek +
To reset the interface (if installing into another vehicle)
With the interface powered, press and hold the rest button. When the LED goes off,
release the reset button. The LED will go to green and the reset is complete.
[email protected]o.uk 01392 829435 In Car Tec, 2 Leigham Units, Marsh Barton, Exeter, EX2 8HY
Setting the jumpers
Open the box. The jumpers are on the left side of the 14 way connector
These may need to be changed depending on the head unit you are fitting or the type of
outputs you require.
1 2 3
J1
J2
J3
J4
J5
JUMPERS
1 - 2 2 - 3
J1 ALPINE - SONY OUTPUT PIONEER OUTPUT
J2 GND BRAKE OUTPUT POSITIVE BRAKE OUTPUT
J3 GND REVERSE OUTPUT POSITIVE REVERSE OUTPUT
J4 BLAUPUNKT DO NOT USE
J5 K-BUS HANDLING CAN-BUS HANDLING
Red button
LED