InCarTec 50-953 User manual

INSTALLATION INSTRUCTIONS
50-953
• ISO DDIN radio provision
• Painted scratch resistant black
KIT COMPONENTS
• A) Radio trim panel • B) Radio brackets
• Panel removal tool • Phillips screwdriver
• 10mm socket wrench • Cutting tool
TABLE OF CONTENTS
Dash Disassembly ..................................................2
Kit Preparation .......................................................2
Kit Assembly ..........................................................3
A B
Kia Sorento
Without 7-inch touchscreen
KIT FEATURES

DASH DISASSEMBLY KIT PREPARATION
1. Unclip and remove the factory radio trim
panel including the a/c vents. (Figure A)
2. Remove (4) Phillips screws securing the
radio. Slide the radio out, then unplug
and remove the radio. (Figure B)
Continue to Kit Preparation
1. Cut the marked area in the dash cavity.
(Figure A)
2. Remove (1) 10mm nut holding the area
previously cut in step 1 to remove the
cut-out area.
3. Snap the radio trim panel into the factory
trim bezel from the back side of the bezel .
Continue to Kit Assembly
(Figure B)
(Figure A)
(Figure A)

KIT ASSEMBLY
(Figure A)
1.Secure the radio brackets to the radio
using the screws supplied with the
radio. (Figure A)
2. Locate the factory wiring harness and
antenna connector in the dash and
complete all necessary connections to the
radio. Test the radio for proper operation .
3. Secure the radio assembly to the
dash using the factory screws, then
reassemble the dash in reverse order of
disassembly to complete the installation .