Infineon EZ-USB BT.1120/LVDS User manual

QUICK START GUIDE
EZ-USB™ BT.1120/LVDS
Camera Interface Kit
DEMO_FX3_LVDS_CAM01
Kit contents
1. EZ-USB™ FX3 BT.1120/LVDS Camera Interface board
2. SuperSpeed USB-C cable
3. DCC-IF9410-3.6-O-13P BT.1120 camera board with
lens from ParanTek
4. FPC cable
5. Quick start guide (this document)
6. Kit casing
The DEMO_FX3_LVDS_CAM01 kit demonstrates streaming of USB
Video Class (UVC) and USB3 Vision (U3V) videos up to 1080p @60fps
from block cameras directly into a PC via the USB-C interface.
www.infineon.com/FX3

Before you start
1. Ensure that you have a PC with the following:
– Windows 10 with USB 3.1 Gen 1
– 1.0 GHz or higher CPU clock
2. Download and install Pleora eBUS Player.
Step 1: Hardware setup
1. Ensure that the switch SW1 on the kit is set to boot in SPI
mode. Move SW1 pin 1 to ON position and pin 2 to OFF
position.
2. Connect the BT.1120 block camera module to the FPC
interface connector (J7) using FPC cable.
SW1 in SPI Boot mode
FPC cable
Quick Start Guide Page 2 of 4
1Set switch SW1 to SPI mode
2Camera module connection to the kit
3. Connect the kit with the PC using the USB-C cable.
3Kit connection with PC

Step 2: U3V streaming from BT.1120 block camera
1. Open the eBUS Player app.
2. Click Select/Connect from eBUS Player..
3. Verify that FX3 is detected as shown and click OK.
4. Click Play to stream the video. .
Quick Start Guide Page 3 of 4
4eBUS player setting for video streaming
5Video streaming

Quick Start Guide Page 4 of 4
FPGA (U10)SPI Flash (U11)
USB-C
connector (J1)
Boot mode
switch (SW1)
FPC connector
(J7)
FX3 (U6)
SDRAM DDR3 (U12)
9-V regulator
(U16)
LVDS Connector (J6)
EZ-USB™ BT.1120/LVDS Camera Interface Kit
Date: 06 / 2023
All rights reserved. © 2023
Infineon Technologies AG
Document number: 002-37959 Rev. **
For additional details, see the kit guide available at infineon kit webpage.