InHand ER805 Operating and maintenance instructions

InHand ER805 5G Edge Router
Quick Installation Manual
V1.3—2021.09

Contents
Overview........................................................................................................................................................1
1 Packing List.................................................................................................................................................1
2 Panel Introduction and Structural Size........................................................................................................3
2.1 Panel Introduction ............................................................................................................................3
2.2 Structural Size...................................................................................................................................4
3 Installation...................................................................................................................................................4
3.1 SIM card Installation........................................................................................................................4
3.2 Antenna Installation..........................................................................................................................5
3.3 Power Installation.............................................................................................................................5
4Access to Internet...................................................................................................................................5
4.1 Wired to Internet...............................................................................................................................5
4.2 SIM Card Dialup ..............................................................................................................................8
4.3 Wi-Fi to Internet ...............................................................................................................................9
5 Quick-Use Guidance .................................................................................................................................11
5.1 Restore to Factory Setting ..............................................................................................................11
5.1.1 Web Setting..........................................................................................................................11
5.1.2 Hardware Restore................................................................................................................12
5.2 Import/Export Configuration..........................................................................................................12
5.3 Log and Diagnose Record ..............................................................................................................12
5.4 Connect to InHand platform...........................................................................................................13
6 Description of Panel Indicator...................................................................................................................13

1
Overview
This manual is a guide for the installation and operation of ER805 series routers from InHand Networks.
Please confirm the product model and packaging accessories (power terminal, antenna), and purchase SIM
cards from local network operators
All statements, information and recommendations in this manual do not constitute any expressed or
implied warranty.
1 Packing List
Each ER805 product includes common accessories, please check carefully when you receive our
products. If there is any missing or damage, please contact InHand sales staff.
InHand can provide customers with optional accessories according to different field. Please refer to the
list of optional accessories for detailed information.
ER805 4G model accessories
Accessories
Unit
Remarks
ER805
1
Ethernet cable
1
LET antenna
2
Magnetic antenna, can change to stick
antenna optionally
Wi-Fi antenna
2
Magnetic antenna, can change to stick
antenna optionally
Power cable
1
Power adaptor
1
Panel mounting lug
4
2 hangers and 2 wall mounting lugs
SIM card needle/slot
1
Rubber pad
4
Certificate and product
warrant card
1
ER805 5G model accessories
Accessories
Unit
Remarks
ER805
1
Ethernet cable
1
5G antenna
4
Magnetic antenna, can change to stick
antenna optionally

2
Wi-Fi antenna
2
Magnetic antenna, can change to stick
antenna optionally
Power cable
1
Power adaptor
1
Panel mounting lug
4
2 hangers and 2 wall mounting lugs
SIM card needle/slot
1
Rubber pad
4
Certificate and product
warrant card
1

3
2 Panel Introduction and Structural Size
2.1 Panel Introduction

4
2.2 Structural Size
Unit: millimeter
3 Installation
Precautions for installation:
● Power supply: 12V DC(9 ～ 48V DC), please pay attention to the power voltage level.
● Environment: Working temperature: -25 ℃～ 70 ℃ , storage temperature: -40 ℃～ 85 ℃ , relative
humidity: 5%~95% (no frosting), equipment surface may be high temperature, please consider the
surrounding environment before installation. Device should be installed in the restricted area.
● Avoid direct sunlight, away from heat source or strong electromagnetic interference
● Support wall hanging.
● Check for cables and connectors required for installation.
3.1 SIM card Installation
ER805 supports dual Nano SIM card. Eject SIM card slot by stabbing the hole in the left via needle
or other pointed thing, and then install SIM card.

5
3.2 Antenna Installation
Rotate the metal interface clockwise until the movable part cannot be rotated, do not hold the black
glue stick to twist the antenna.
NoteER805 supports 4 antennas, please install all antennas to obtain high communication quality.
3.3 Power Installation
ER805 uses round hole power supply, just insert power cable into the power interface.
4Access to Internet
ER805 supports three ways of accessing the Internet: wired, cellular and Wi-Fi. When ER805 does not
access to Internet via cellular, please disable the "dial-up interface", otherwise the device will restart after
trying dial up and fail for several times.
4.1 Wired to Internet
Step 1: Connect power and Ethernet cable to ER805, connect WAN port to public network, and one of
LAN to PC.

6
Step 2: Configure PC to be in the same network segment as the IP address of the router.
(1) Enable PC to obtain an IP address from DHCP automatically (recommended).
(2) Configure a fixed IP address in the same network segment as the router for PC. The IP
address should be one of the address in 192.168.2.2~192.168.2.254, Subnet mask should be
255.255.255.0, and Default gateway should be 192.168.2.1. DNS server should be 8.8.8.8 or the
address of ISP’s DNS server.
Step 3: Access to the default IP address 192.168.2.1 in a browser, enter username and password
(adm/123456 by default) and then access to router’s WEB management page. If the browser alarms
the connection is not private, show advanced, and proceed to access to the address.
Step 4: Create a WAN port in “Internet” in the left menu. ER805 wiill enable WAN1 as DHCP mode by
default. It will connect to Internet is the upstream device also works in DHCP mode.

7
There are two methods to obtain IP address: Dynamic DHCP (recommend) and Static IP (save after
configure manually).
Obtain IP address by Dynamic Address (DHCP)
Obtain IP address by Static IP
Step 5: Check the connectivity in “System >> Tools >> Ping”.

8
4.2 SIM Card Dialup
Step 1: Insert the SIM card when device is power off. Connect 4 4G/5G antennas to the router, and
connect PC to router. Then power on.
Note:
When insert or plug out SIM card, please unplug the power cable to prevent data loss or damage the
router.
Step 2: Open a browser and access to router’s WEB management page. (refer to 4.1)
Step 3: Click “Internet”, click Edit button in the right of Cellular to set dialup profile. The device
enables the cellular by default, it will connect to Internet within a few minntes. If the device cannot
connect to Internet, please disable and restart dialup. (If you use a private network SIM card, you also
need to configure APN parameter)

9
Step 4: Check the dialup status in “Dashboard >> Interface Status”, if it shows green in Cellular icon,
the router has connected to Internet by SIM card. Click Cellular icon to get check more dialup
information like signal strength, IP address or DNS.
4.3 Wi-Fi to Internet
Step 1: Connect Wi-Fi antenna, and connect PC to the device. Access to router’s WEB management
page. (refer to 4.1)
Step 2: Choose the frequent band of Wi-Fi. ER805 supports 2.4G and 5G Wi-Fi. These two Wi-Fi can
work independently at the same time. 2.4G Wi-Fi has higher penetration while 5G Wi-Fi has higher
transmission speed. You can check Wi-Fi status in “Wi-Fi” of the left menu.
Step 3: Set Station Role in “Wi-Fi 2.4G” or “Wi-Fi 5G”: AP or Client.
AP mode (default mode): ER805 acts as an accsess point to radiate wireless signals, and other
terminal devices can connect this device to access the Internet. It is necessary to ensure that ER805
itself has been connected to the Internet through wired or dialup mode. AP mode supports setting

10
SSID name and encryption authentication mode, and terminal devices will need to input password
when connecting.
Client mode: ER805 connects to other AP Wi-Fi device to access the Internet.
Click Add button in “Internet” page, select “Wi-Fi(STA)” and then configure other parameters.

11
5 Quick-Use Guidance
5.1 Restore to Factory Setting
5.1.1 Web Setting
Login to the WEB management page, click "System" in the left menu. Click "Restore to factory"
button in “Device Options”, router will restore to default settings after reboot.

12
5.1.2 Hardware Restore
To restore to default settings via the reset button, please perform the following steps:
1. Press the RESET button immediately after power on the device.
2. System indicator will blink after a few seconds, and after blinking for about half a minute, it will be
steady on.
3. Release RESET button, System indicator will blink, and press the RESET button again.
4. When System indicator blinks slowly, release the RESET button. The device has been restored to
default settings and will start up normally later.
5.2 Import/Export Configuration
Click "System" in the left menu and then click “Configuration Management”. User can export system
configuration to local PC, and import the configuration when device gets error in this page.
5.3 Log and Diagnose Record
Click “Export Events” button on the right in “Status” page to export event log to PC, and in “System >>
Tools”, user can export Diagnose log to PC.

13
5.4 Connect to InHand platform
Access to Incloud Manager (star.inhandcloud.com), follow the prompts to register an account and then
login. Click "Add" in "Device" page, enter "Device name" as you wish and enter the "Serial Number"
in router’s "Dashboard" page. Click "Save". Platform will verify the serial number and add the device
to your account.
Then you can check and manage the router in platform after adding it successfully.
6 Description of Panel Indicator

14
ER805
Indicator
LED Status and Definition
System
Steady off --- Power off.
Blinking in blue --- System starting.
Steady in blue --- System operates properly.
Blinking in red --- System faults.
Blinking in green --- System upgrading.
Network Status
Blinking in red --- Network connection lost.
Blinking in green --- Cellular network connecting.
Steady in green --- Cellular network connected.
Blinking in blue --- Ethernet network connecting.
Steady in blue --- Ethernet network connected.
Wi-Fi 2.4G
Steady off --- Disabled.
Steady in green --- Wi-Fi 2.4G connecting.
Blinking in green --- Wi-Fi 2.4G working properly.
Wi-Fi 5G
Steady off --- Disabled.
Steady in blue --- Wi-Fi 2.4G connecting.
Blinking in blue --- Wi-Fi 2.4G working properly.
Note: If both cellular network and ethernet network are working properly, Network Status Indicator will be
in blue. And it will show the color of the connecting network if another network is not connected. If either
two network are not connected, this indicator will be in red.