innowi ChecOut M User manual
This device complies with Part 15 of the FCC Rules.
Operation is subject to the following two conditions:
(1)
this device may not cause harmful interference and
(2)
this device must accept any interference received,
including interference that may cause undesired
operation.
Note: This equipment has been tested and found to
comply with the limits for a device, pursuant to Part 15
of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference.
This equipment generates, uses and can radiate radio
frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful
interference to radio communications.
Caution: Changes or modifications not approved by
Innowi could void the user’s authority to operate the
device.
FCC RF Exposure Information (SAR)
This device is designed and manufactured not to
exceed the emission limits for exposure to radio
frequency (RF) energy set by the Federal Communica-
tions Commission of the United States.
During SAR testing, this device is set to transmit at its
highest certified power level in all tested frequency
bands and placed in positions that simulate RF
exposure in usage near the body. Although the SAR
is determined at the highest certified power level, the
actual SAR level of the device while operating can be
well below the maximum value. This is because the
device is designed to operate at multiple power levels
so as to use only the power required to reach the
network.
Smart. Secure. Sophisticated. Simplified.
by
1. Connect the power adapter cable to
the ChecOut M USB-C connector and
plug-in to the wall socket.
Scanner Operation
Point the ChecOut M device towards the
barcode on an item to scan. For
best results keep the ChecOut M device
within 6-10 inches from the barcode.
2. Turn on the device by pressing the
power button for a few seconds. You will
see the “ChecOut” display screen turns
on and the device begins to power up.
3. From settings menu, Scanning and
Payment functionalities can be turned
on/ off. Wait for a few seconds before
start using scanning and payment
functionalities.
4. Use only Innowi provided chargers,
batteries, and cables. Non-Innowi
chargers or cables can cause the battery
to explode or damage the device.
5. When charging ChecOut M device using
USB charger or Charging Dock, remove the
device from charging once device is fully
charged.
6. If the device is not in operation, fully charge
the device, remove it from charging and
power off the device completely.
7. For questions related to POS applications,
payment gateway or payment processing
please contact your provider.
1. Insert SD card ejection tool or a paper
clip into the small hole to remove the SD
card.
2. Remove the SD Card tray from the
ChecOut M device. When reinserting the
SD card ensure that it is in the proper
orientation relative to the tray.
Recommended Usage
We recommend you hold the ChecOut M in
your non-dominant hand while using your
dominant hand to take the payments
and to carry out other standard device
operations.
Payment Methods
ChecOut M Tablet can be used to take
payments using MSR, Chip Card and NFC as
shown in the picture below
Support
For any questions and comments, please contact
innowi.com
