Instant Comfort Q5 User manual

Assembly Instructions
Video Instructions available at
www.instantcomfort.com/assembly
Q5, Q6, Q7, Q7-T, Q8, Q9
S6, S7, S7-T, S8, S9
1. Unpackage all components & verify you
have everything required.
Immediatly discard all packaging as it can pose a
choking hazard.
1 Top Cover
1 Comfort Layer
1 Center Panel
1 or 2 Air Chambers
1 Support Layer
1 Unwrapped Rail Set
1 Bottom Cover
1 Air Control System
2. Ensure you have a base, foundation, or
adjustable platform ready for your new
bed.
3. Place the bottom cover of the mattress on
the foundation, with the zipper side up.
Position the two holes at the head of the
bed.
4. Insert the head, foot, & side rails inside the
bottom cover. Position the rails so that “This
Side Up” is up & visible. The rails will have a
snug fit when correctly installed.
6. If your mattress has two chambers,
place one in before the other & be sure
to pass the tubes through the holes in
the bottom cover.
7. Connect the tubes from the air
chambers to the connectors on the air
control unit. Press the two ends
together until you hear a “Click.” Be sure
to keep track of which hose connects to
which side of the pump.
7. Connect the air control unit to a
powered surge protector & plug the
hand controls into the each side. The
hand control will operate the air
chamber on the side that it is plugged
into.*
*a surge protector is not included but is strongly reccomended to prevent
electrical damage not covered by the warranty.
See the instantcomfort.com/warranty for more information.
5. Place the foam support layer
between the rails and smooth it out to
fill the entire base.

8. When the controller boots, simply press 1
& the chamber will auto-inflate. Wait until the
pump is finished filling the air chamber, then
press 1 on the second hand control to fill the
other chamber where necessary. Note that
inflation may take up to 5 minutes per side, &
the pump will only fill one side at a time.
9. Once both air chambers have been filled,
make sure that they are positioned evenly
inside the foam rails.
11. Place the top panel across the top of
the mattress with the tag facing the head
of the bed.
12. Zip the top panel onto the center
panel, being careful not to snag any
internal materials.
13. Now, find your ideal setting! We
reccomend starting at the most firm
setting, & reducing firmness until it is
softer than you would like, & gradually
increase in firmness until you find your
ideal setting.
10. Place the comfort layers on top of the
center panel.
10. Place the center panel across the top of
the chambers & zip it on.Ensure the fire
barrier fabric is between the side wall and
foam rails.
Make sure the fire barrier fabric is placed over the
foam rails as shown to the right.
Make sure the fire barrier fabric is placed over the
foam comfort layers as shown to the right.
If you have any problems, questions, or
comments feel free to visit us at
www.instantcomfort.com
Thanks for your purchase, and we hope you
enjoy a great night’s sleep!