Hay BUTLER User manual

– CARE GUIDE –
BUTLER
13/11/2019

– BUTLER –
Born from the desire to create a versatile step ladder
to fit modern urban lifestyles, Shane Schneck has
created in Butler a clever and multifunctional
household item.
Providing two extra steps when used as a ladder, the
larger lower step allows it to be utilised as a side
table, stool or bedside bench when not serving
its primary function.
Crafted in solid oak with contemporary detailing,
Butler comes pre-assembled and ready to use.

With a little care you can prolong the life
of your furniture. Follow the instructions for
the materials of your specific product to
make sure that it stays in the best shape
for as long as possible.
The information below is only intended as
a general guideline. For more information
on how to remove specific stains, please
enquire where you bought the furniture.
/Always remove stains quickly before
they can do any permanent damage to
the furniture.
/Avoid placing the furniture in direct
sunlight or near a strong heat source
to reduce changes. As wood is a
natural material, it will change in
colour and will patinate over time.
/When you move your furniture, make
sure you lift it rather than pulling or
pushing it to avoid damaging the floor,
legs and mountings.
/Be careful not to scratch or damage
the surface with sharp objects.
/Avoid covering the surface partially,
for example with cushions or skins, as
colour variances may appear.
– CAUTION –

– CARE GUIDE –
OILED WOOD
Wipe with a clean, dry cloth. If the surface
is dirty, wipe with a clean cloth wrung in
water or in a solution of water and a neutral
detergent or soap flakes. Remove any soap
residue immediately using a clean, dry
cloth. Never use soft soap or solvents such
as spirit, turpentine or acetone.
Avoid using scouring cream or scouring
pads, as they may scratch the surface. If
the surface is scratched or appears matt,
make sure to use an oil hardening care
product specifically designed to maintain
oiled wooden surfaces.
Clean the furniture thoroughly (12 hours)
before applying the oil to all surfaces. To
ensure optimal absorbency, gently sand
down the wood using fine-grit sandpaper
(No. 180 or 240), always sanding in the
direction of the grain. Apply the oil
generously using a clean cloth or a sponge,
always applying in the direction of the
grain. Do not pour the oil directly on the
surface.
When the surface is glistening, leave
the oil on for around two hours until fully
absorbed. Remove any excess oil with a
clean lint-free cloth. Leave the furniture
to dry overnight (min. 12 hours) and avoid
placing anything on the surface before it is
completely dry.
If the grain of the wood rises after oiling,
gently sand down the wood using fine-grit
sandpaper (No. 180 or 240), always sanding
in the direction of the grain. To optimally
maintain the naturally beautiful appearance
of the wood, we recommend you
regularly treat the furniture’s surface with
oil whenever it appears dull, scratched or
as needed.

Havnen 1 8700 Horsens Denmark
[phone] / [e-mail]