Intermec CN2A User manual

CN2 Serial Adapter Instructions
Use the CN2 Serial Adapter (P/N 074247) to turn the 16-pin serial
port (COM1) on the CN2 into a DB9 (9-pin) male serial connector
that you can connect to a serial printer or a button link.
Installing and Using the Serial Adapter
1Remove the serial port plug from the serial port.
Clips
DB9
connector
Serial
port plug
2Slide the serial adapter onto the CN2 and snap the two clips into
place on the CN2.
3Connect a serial printer or button link to the DB9 connector on the
serial adapter.
Removing the Serial Adapter
1While holding the CN2, push down on the serial adapter until the
clips are released from the CN2.
Clips
2Slide the adapter off the CN2.

CN2 Serial Adapter Instructions
*074758-002*
P/N 074758-002
DB9 Connector Pin Assignments
Data set ready (DSR) - 6
Button link power - 7
Clear to send (CTS) - 8
Not connected - 9
1 - Not connected
2 - Receive data (RXD)
3 - Transmit data (TXD)
4 - Button link power
5 - Ground
Pin Assignments: This illustration shows the pin assignments for the DB9 male
connector on the serial adapter. Pins 4 and 7 supply power to the button link.
Pin 9 does not supply power to external devices.
Specifications
Electrical rating: x7.4 V, 20 mA peak
Communications port: DB9 male connector,
RS-232 without RI, CD, DTR, and RTS
Operating temperature: 0°C to 50°C (32°F to 122°F)
Storage temperature: -10°C to 50°C (14°F to 122°F)
Relative humidity: 5% to 95%, non-condensing
Serial port settings: Baud Rate 115200
Data Bits 8
Parity N
Stop Bit 1
Flow Control None
Use an application to change
these settings.
6001 36th Avenue West
Everett, Washington 98203
U.S.A.
tel [phone]
fax [phone]
www.intermec.com
©
2005 Intermec Technologies
Corporation. All rights reserved.