Intermec IV6 User manual

Installation
IV6
Portable Reader
Instructions
Power Cable Kit

2 IV6 Portable Reader Power Cable Kit
Power Cable Kit (p/n: 203-714-001)
Packing List
Ensure you have received these items:
SIV6 Power Cable Kit Installation Instructions
S17-Position cable assembly (p/n: 236-040-001)
SFuse holder
S5 Amp./250 volt fast acting fuse
S3/8” heat shrink tubing (6 inches)
S1/4” heat shrink tubing (6 inches)
SCable ties (6)
SAdjustable cable clip
S2-Pin circular connector

3
IV6 Portable Reader Power Cable Kit
Instructions
1Cut back the cable assembly jacket about 18 inches.
2Cut the purple wire and solder in the fuse holder. Install the
5 amp. fuse into the holder.
3Attach heat shrink tubing to the connections on the fuse
holder. Use a heat gun to seal the heat shrink tubing.
4Usethetiewrapsonthecableassemblywires.Attachthe
cord clip to an appropriate location to ensure the cables are
not obstructing the user’s operation of the equipment.
5Attach the purple wire and blue wire to the 2-pin connector.
Attach heat shrink tubing where the connector and wire as-
sembly meet. Use a heat gun to seal the heat shrink tubing.
6Connect the 2-pin connector to the Intermec power supply
(p/n: 851-041-002). Connect the circular data connector to
the Reader.
7The remaining wires on the cable are data lines (RS-232) and
general purpose input/output lines. Refer to the GPIO Pin
Function/Assignment Table in the IV6 Portable Reader
Quick Start Guide (p/n: 962-054-119) for details.
8Connectthecablefromthepowersupplytothevehiclepow-
er source.

Corporate Headquarters
6001 36th Avenue West
Everett, Washington 98203
U.S.A.
tel 425.348.2600
fax 425.355.9551
www.intermec.com
IV6 Power Cable Kit Installation Instructions
*962-054-127A*
P/N 962-054-127A
e2005 by Intermec Technologies Corporation. All rights reserved.