8 Apriva BT200-T Smart Card Reader User’s Guide
If the LED is not blinking after you press the Power button, you need
to charge the SCR for 30 or more minutes. After 30 minutes, you need
to check the status of the indicators by inserting a smart card.
Checking and Charging the Battery
The SCR takes approximately 3 hours to charge its internal battery.
You can use the wall charger or a USB cable to charge the SCR.
To check the status of the battery
•Press the Power button and observe the status LEDs. For more
information on the status LEDs, see “Understanding the Power
Button and LEDs” on page 7.
To charge the battery using the wall charger
1Attach the SCR to the wall charger.
2Insert the wall charger into an electrical outlet.
3The green LED turns on indicating that the SCR is charged.
Common access
card has been
inserted for more
than four
seconds.
Flashing green
or red every one
second.
Connection between the mobile
computer and the SCR has been
established, and the SCR is ready for
operation.
You connect the
USB cable.
Solid green SCR is being charged, and cannot be
used.
Note: You can use the SCR when you
are charging with the wall charger, but
you cannot use the SCR when a USB
connection is the main power source.
You remove the
Smart card or
charge cable.
Green and red
flash once
When you press the Power button, the
LED flashes to provide a visual clue
that the SCR has been powered off.
Understanding the Status LEDs (continued)
Action LED Status Description
