Invacare 1038599 Assembly instructions

Part No 1039644 1Wheel Lock Extension Handle
For more information regarding Invacare products, parts, and services, please visit
www.invacare.com
Wheel Lock Extension Handle
Kit No. 1038599
NOTE:Checkallpartsforshippingdamagebeforeusing.Incaseofdamage,DONOTusetheequipment.Contactthe
Dealer/Carrierforfurtherinstructions.
Safety Summary
ThefollowingrecommendationsaremadeforthesafeinstallationoftheWheelLockExtensionHandleKit:
 WARNING
DO NOT use this product or any available optional equipment without first
completely reading and understanding these instructions and any additional
instructional material such as owner’s manuals, service manuals or instruction
sheets supplied with this product or optional equipment. If you are unable to
understand the warnings, cautions or instructions, contact a healthcare
professional, dealer or technical personnel before attempting to use this equipment
- otherwise, injury or damage may occur.
Any worn or damaged hardware must be replaced.
After any adjustments, repair or service and before use, make sure all attaching
hardware is tightened securely.
 ACCESSORIES WARNING
Invacare products are specifically designed and manufactured for use in conjunction
with Invacare accessories. Accessories designed by other manufacturers have not
been tested by Invacare and are not recommended for use with Invacare products.
NOTE:Ifinstallingthiskitonawheelchairmanufacturedpriorto5/93,anewstylewheellockhandlemayneedtobeordered.
ContactanInvacareDealerorCustomerServiceatthenumberonthebottomofthisinstructionsheet.
Installing The Wheel Lock Extension Handle
NOTE:Wheellockextensionhandlescannotbeinstalledonhighmountwheellocksalreadyequippedwithextensionhandles.
1. Removeanddiscardtheexistingrubbertiponthewheellockhandle(ifapplicable).
2. Removethebuttonscrew,washerandlocknutthatsecurestheexistinghandletothewheellockassembly.
3. Attachtheloopedendoftheelasticcordofthewheellockextensionhandleoverthespaceroftheexistinghandle.
4. Reassembletheexistinghandletothewheellockwiththebuttonscrew,washerandlocknuttosecurethecord
aroundthespacer.Tightensecurely.
NOTE:Cordismadeofstretchablematerialandmaybeadjustedtoalightorloosefittomeettheneedsoftheuser.
5. Slidewheellockextensionhandleoverexistinghandle.
Assembly, Installation and Operating Instructions
SAVE THESE INSTRUCTIONS

FIGURE 1 Installing The Wheel Lock Extension Handle
Elastic Cord
Spacer
Button Screw
Wheel Lock Assembly
Wheel Lock Extension Handle
Existing Handle
Locknut
Washer
Invacare Corporation www.invacare.com
USA
One Invacare Way
Elyria, Ohio USA
44036-2125
For Customer Service, call
800-333-6900
Canada
570 Matheson Blvd E
Unit 8
Mississauga Ontario
L4Z 4G4 Canada
800-668-5324
All rights reserved. Trademarks are identified
by the symbols ™ and ®. All trademarks are
owned by or licensed to Invacare Corporation
or its subsidiaries unless otherwise noted.
©2009 Invacare Corporation
Part No 1039644 Rev D - 7/09