Invacare 1049522 Assembly instructions

Form No. 94-148
1
SAFETY SUMMARY
Check all parts for shipping damage before using. In
case of damage, do not use. Contact the dealer for further
instructions.
NOTICE
The information contained in this document is subject to
change without notice.
WARNING
DO NOT install, maintain or operate this equip-
mentwithoutreading,understanding,andfollow-
ingtheproperInvacareinstructions,otherwisein-
jury or damage may result.
Yourtherapistandphysicianshouldbeconsulted
ifyouhaveanyquestionsregardingindividuallimi-
tations and needs.
HEADREST REINFORCEMENT
PLATE INSTALLATION FOR THE 12,
14, 16, 17, 18 AND 20-INCH
PERSONAL BACK
NOTE: 13, 15 and 19-inch Personal Backs have an ex-
isting reinforcement plate.
1. Remove the Personal Back from the back canes.
2. Remove the zippered cover from the Personal Back.
3. Mount the Personal Back in bench vise with the front
facing you.
4. Push the foam of the Personal Back downward.
5. With hole closest to top edge in the middle of rein-
forcement plate (marked "A" - Refer to FIGURE 2)
align Personal Back (FIGURE 1) dimples on inside
with TOP two (2) corner holes of the reinforcement
plate. Clamp plate to Personal Back.
6. Drill (from the inside of the Personal Back) the
TOP two (2) corner holes with a 3/16-inch drill bit.
7. Unclamp the reinforcement plate and turn the Per-
sonal Back around in the vise.
8. Clamp the reinforcement plate to the outside of the
Personal Back, aligning holes on plate with holes
drilled in Personal Back.
9. Drill (from the outside of the Personal Back) the
BOTTOM two (2) corner holes with a
3/16-inch drill bit.
10. Drill mounting holes in Personal Back for the selected
headrest. Refer to FIGURE 2.
11. Unclamp the reinforcement plate and turn Personal
Back around in vise.
12. Mount reinforcement plate on inside of Personal Back
(FIGURE 1).
NOTE: Position heads of button head screws on the
inside of the backrest.
13. Secure reinforcement plate to Personal Back with
button head screws and hexnuts.
NOTE: Use appropriate holes in reinforcement plate for
mounting selected headrest.
Personal Back Headrest Reinforcement Plate
Assembly, Installation and Operating Instructions
Kit No. 1049522

ITEM NO. DESCRIPTION QUANTITY
1. Headrest Reinforcement Plate 1
2. Screws 10-32 x 1/2-inch 4
3. Locknuts 4
4. Instruction Sheet 1
2
This Hole Toward
Top Of Backrest
Push Foam Down For
Assembly Procedures
Kit No. 1049522 includes the following:
Cut Out For
Visual Clarity
HOLE APPLICATIONS
A = Canyon
B = Whitmeyer
C = Otto Bock
D = Otto Bock
E = Freedom
F = Mounting Hole
G = Pindot
FIGURE 2 - HOLE APPLICATIONS
FIGURE 1 - HEADREST REINFORCEMENT PLATE INSTALLATION
1
3
Invacare Corporation www.invacare.com
U A Canada
One Invacare Way 5970 Chedworth Way Invacare is a registered trademar of Invacare Corporation.
Elyria, Ohio USA Mississauga, Ontario ©
1999 Invacare Corporation
44036-2125 L5R 3T9, Canada
800-333-6900 800-668-5324 Form No. 94-148 Part No. 1049521 Rev F (1) 7/00