IPC Gansow CT 80 Series User manual

CT80 Quick guide
This guide is intended for quick consultation only and is not intended to replace the user and maintenance manual.
Before using the machine, read the user and maintenance manual contained in the machine’s packaging thoroughly and strictly
follow all the instructions.
PREPARATION & OPERATION
Fill the solution tank.
Switch the machine on by turning the
ignition key.
Press the AUTO or ECO button; in both
modes, all the machine’s functions will
be activated. In ECO mode, the machine
consumes less energy and operates
more silently.
Select the direction of travel.
Adjust the machine’s speed using the +
and - buttons.
Press the accelerator pedal.
Start work.
When having nished cleaning, proceed
as follows:
• Press the AUTO or ECO button to
switch off the machine’s functions.
• Turn the ignition key.
• Recharge the batteries.
DAILY MAINTENANCE
Empty the dirty water tank through the
drain hose
0,500Lt
0,400 Lt
0,250 Lt
0,100Lt
CHEMICAL
0,500Lt
0,400 Lt
0,250 Lt
0,100Lt
-1
-3/4
-1/2
-1/4
CHEMICAL
APC
APC
APC
1

Clean the dirty water tank
Check that the suction lter is undam-
aged and clean
Check that the detergent outlet lter is
undamaged and clean
Clean the brushes
Check that the squeegee is clean and the
blades are not damaged
REPLACING THE SQUEEGEE BLADES
• Open the clip (Ref. 1).
• Remove the two blade retainers (Ref. 2) by pushing them outwards then extracting
them.
• Remove the blade.
• Reuse the same blade by reversing the edge in contact with the oor until all four
edges are worn out, or replace with a new blade, tting it onto the pins on the body
of the squeegee.
• Reposition the two blade retainers by centring the widest part of the slots over the
xing pins on the squeegee body, then pushing the blade retainers inwards.
• Fasten the clip.
• Put the squeegee back on its support, following the instructions described previously.
ATTACHING/REMOVING THE BRUSHES
Position the brush underneath the head, in the centre (single-brush oor scrubber), position the brushes underneath the head on
both sides (double brush scrubber), switch the machine on.
Pressing the ATTACH/RELEASE button once after starting the machine releases the brushes, pressing the button a second
time activates automatic brush attachment. The button is only enabled when all the functions are deactivated (suction motor and
brushes).
IF THE MACHINE IS NOT USED FOR AN EXTENDED PERIOD, UNPLUG THE EMERGENCY CONNECTOR
TO AVOID DISCHARGING THE BATTERIES.
1
2
1
2