IPC Gansow CT40 User manual

PEDESTRIAN SCRUBBER DRIER CT40
Operating & Care Guide
LED Display
Ignition Switch/Stop
40 litre solution tank Potentiometer (Speed)
50 litre recovery tank Forward/Reverse
45 cm (18”) 50 cm (20”) Brush Start/Stop
55 cm (22”) scrub widths. Vacuum Start/Stop
Battery Level Indicator
Recovery Tank Full
Solution Tank Empty
MACHINE OPERATION DAILY CARE
1. Fill Solution Tank. 1. Drain Recovery Tank
2. Ignition Switch On 2. Flush Recovery Tank with Clean
Water & Wipe Off Float Swit ch
3. Lower Brush Head by Foot 3. Remove Vacuum Filter & Wash
Pedal. Press Down & to Left with Clean Water.
4. Lower Squeegee 4. Remove Squeegee Assembly &
Clean – Ensure Blades are Clean
and Edges are
‘Sharp’
5. Remove Brushes or Pads & Clean.
Solution Flow
5. Select Forward Traction From Centre of
Brush.
6. Wipe Down Machine
6. Open Solution Flow Lever
7. Charge Batteries – On Board
or External Charger 24v x 20A.

CT40 - Get Out Of Trouble ‘Quick’ Guide
PROBLEM / FAULT SOLUTION
1. MACHINE IS DEAD / NO POWER:- Check emergency stop button is not
depressed.
Check Batteries are Connected & Charged.
2. VACUUM WILL NOT OPERATE:- Check recovery tank is not full.
Check float switch is not dirty & stuck open
3. POOR DRYING:- Check squeegee blade is not worn or torn.
Check debris is not caught in the squeegee
blade.
Check debris is not in suction hose.
Check vacuum filter is not dirty & blocked.
Check recovery tank lid is tight & rubber
‘0’ ring is in place.
Check vacuum hose is connected to the
Squeegee OK.
4. FLOOR IS DIFFICULT TO CLEAN:- Worn or wrong type of brush / pad.
5. STREAKY FLOORS:- Floor has not been pre-swept.
Torn or dirty squeegee.
Debris in squeegee, or Dirt on Rubbers.
Squeegee set incorrectly, Rake Angle -
Angle of Blade, (30◦to 40◦).
Using the Correct Chemical or Solution Flow Rate.
CHANGING SQUEEGEE BLADES LOCATING/CHANGING BRUSHES
IPC Gansow Squeegee rubbers have 4 working The CT40 has auto/brush pick up / drop. Place
edges. Release toggle clamp, slide & remove brush / pad under the brush head from the
the metal strap, peel off the squeegee rubber, front, centralise using the brush cover as a
turn over and replace locking toggle clamp. guide, switch on brush operation, lower brush
head, switch on brush, start with the operating
lever, the brush will then engage.
Check Rubber Edges are ‘Sharp’ of the blade,
Remember you have 4 x Edges to the Blade.
Squeegee Rubbers & Assembly to be Cleaned
CT40BT50 Pad Holder = 1 x 460 mm Dia.
Daily. CT40BT55 Pad Holder = 1 x 505 mm Dia.
Single disc models have auto brush on/off
For full operating instructions, please refer to the IPC Gansow Operator Handbook.
If you require further information or assistance, please contact:-
IPC Gansow (UK)
Unit 7, Tame Valley Business Park,
Magnus,
Tamworth,
Staffordshire,
B77 5BY.
Office Tel: [phone]
Office Fax: [phone]
Mobile: [phone]
Email: [email protected]
Web Site: www.ipcgansow.com
IPC Gansow – Manufacturers of Industrial Cleaning Equipment