Iridex CYCLO G6T User manual

Quick Setup Guide*
Turn key to “On.” Wait
for the intialization to
complete.
STEP 1
Plug in probe.
STEP 2
Press “OK” on defaults
screen.
STEP 3
Press “OK” on Safety
Warning Screen.
STEP 4
Press “Preset.”
Note: Please refer to the Cyclo G6
Operator Manual to create a new
preset.
STEP 5
CYCLO G6
TM
Press desired preset.
STEP 6
Press “Select”.
STEP 7
Press “Treat” button.
“Treat” button will turn
a constant green and
laser is ready.
STEP 8
Press here.
RESETTING COUNTDOWN TIMER
Parameters shown here are for illustration only.
Treatment parameters are solely at the discretion of the treating physician.

*Please reference the CYCLO G6 Operator’s Manual for more
information on maintenance, safety precautions and any cleaning,
disinfecting instructions.
©2015 IRIDEX. Printed in USA LT0625 11/2015
Quick Setup Guide*
Not a substitute for the Operator’s Manual.
VISIBLE AND INVISIBLE LASER RADIATION
AVOID EYE OR SKIN EXPOSURE TO
DIRECT OR SCATTERED RADIATION
CLASS 4 LASER PRODUCT
CLASS 2 LASER PRODUCT
(IEC 60825-1:2007)
λ= 810 nm PO= 3 W
λ= 635 nm PO= 1 mW
1212 Terra Bella Avenue
Mountain View, CA 94043 USA
800.388.4747 (U.S. inquiries)
[email protected] (U.S. & int’l inquiries)
www.iridex.com
WEEE Guidance. Contact IRIDEX or your
distributor for disposal information.
Emergo Europe
Molenstraat 15, 2513 BH, The Hague, The Netherlands
Tel.: (31) (0) 70 345-8570, Fax: (31) (0) 70 346-7299
EC REP
CYCLO G6TM