Irritrol Platinum Sport Manual

Align the cap arrow with the
left side stop of the watering
area. This is the non-adjustable
side of the watering arc.
Watering Arc Adjustment
Use the sprinkler
tool or a
screwdriver to
adjust the right
stop of the
watering arc.
Rotate clockwise
to increase or
counter-clockwise
to decrease.
The left stop indicates the fix point or 0° of the arc. The arc
angle will determine the right stop of the watering arc.
Align the right stop to the watering area
by adjusting the watering arc angle.
360°45°
180°
The watering area can be adjusted between 45° and
360°. When set to 360°, the nozzle does not reverse
direction.
90°
Watch the arc
indicator pointer
move to mark the
precise arc angle
when adjusting.
To pull the nozzle
riser up, insert the
tool into the cap, twist
1/4 turn and pull.

Changing Nozzle
Adjusting Spray
Remove and
flush screen
as needed.
Cleaning Screen
The riser is keyed
to fit the body in
one position to
maintain the left
stop setting. Insert
the riser into the
body and rotate it
until it is seated
properly.
© 2010 Irritrol • www.irritrol.com Form Number 373-0355 Rev. B
Check Valve
The check valve is factory
installed in position A.
The Platinum Sport Rotor comes
with seven nozzle sizes from
7 to 27 GPM (31.8 to 122.7 LPM). To
change the nozzle, insert the blade
end of the sprinkler tool or a
screwdriver through the cap. Turn
the nozzle screw out until it clears
the nozzle. Pry the nozzle out at the
bottom and install the new nozzle.
Return the nozzle screw to its
previous position.
Turn the nozzle screw in to diffuse
and shorten the spray radius.
The Platinum Sport Rotor is
equipped with a two-way check
valve. To eliminate check valve
function, install the check valve
disk in position B.